JDcrawlers Messageboard

I've been looking for an affordable, good used sprocket for quite some time now with no luck. I may just have to resort to some type of custom made insert or the hard surface approach as Jim suggested.

Any opinions on weld in sprocket inserts. One of the sprockets on my 2010 is is need of serious help.

If a template or drawing is located, I would be very appreciative to get one also. thanks, chet

Bottom line for me and my decision was cost.

It's been over 6 years now and the only thing I've done other than filters and oil has been an ignition tune up last fall.

sm-2037 ,at least that is the English version

Was the distributor removed from the engine for the repair work? If so was it possibly installed 180 degrees off when reinstalled. Also something I did once in a daaa moment was to install plug wires assuming the distributor turned in a different direction than it did.

One of the problems I ran into when installing the gas engine into my diesel 2010, was the governor that came on the gas engine would not work with some of the interchanges that had do be done for the install. It's been awhile but if I remember right it had to do with the water pump. I installed a g...

Yes the exhaust manifold is different. Check out this earlier post, it might be helpful.

http://www.jdcrawlers.com/messageboard/ ... highlight=

This may be a dumb question. But did you check and make sure it's oil, and not the remains of a can of "stop leak" some one may have dumped in?

keep in mind that the 165 is pushing out more HP than what was originally in that 1010.

I posted a link in the post above that may answer a few questions.

I put the same engine in my 2010. The conversion was not without some issues, but wit a little head scratchin' I was able to pull it off. I'm very happy with the results.

http://www.jdcrawlers.com/messageboard/ ... highlight=

300.00 is what I payed for the 165 gas combine engine I put in my 2010. I was able to hear it run before I bought it. Lots and lots of hours on it since the install, great oil pressure and still purrs like a kitten.

I didn't block soon enough, and got bit this fall too. I got lucky, drove mine around for about an hour or so, and it freed right up.