JDcrawlers Messageboard

Can anyone tell me how to hook up an electric temp gauge on my 1966 1010c? my system is 12volt positive grd. Thank's Ed

Hello, I am in the process of changing the ignition switch, when I got the machine it was hot wired after testing the switch it is bad I'm guessing thats the reason for it being hotwired. There are two plugs that were removed and just hanging; one is a double red wire one wire goes to the negative s...

Can anyone tell me the best way to time the engine also the carb was leaking fuel through the air intake port so we purchased a kit, we installed a new needle and seat checked the float for leaks reinstalled it and adjusted it according to the info that came with the kit, we still have the same prob...

1010C

I'm working on replacing some of the hydraulic lines it has a two lever valve one for the blade and one for what ever attachment would be used in the rear of the tractor. It has another lever on the same side with a 1" hose, one end comes from the outlet of the two lever valve and the other goes to ...

I'm in the process of adjusting the foot brake on my 1010C and the linkage rods were cut and welded at different lenghts which adds to the confusion, the manual says to move the pedal forward to the stop and pull the rods forward to the end of their slots and adjust the clevis so the pin just slides...

I removed the top plate from the transmission and found coffee colored sludge and ice :?: , I assuming water is the culprit. Can any tell me how the water might have gotten in the trans?

Gentlemen, I recently aquired a 1010 crawler from a relative, the unit has been sitting outside for three years. The bolts on the passenger side final drive are broken and the tranny is stuck in gear and will not shift. The dozer moved and steered when I loaded it. My uncle said everything was worki...