Search found 6 matches
- Fri Feb 05, 2010 11:16 am
- Forum: Late model JD crawler technical support
- Topic: 350b fuel pump shaft seal
- Replies: 8
- Views: 9360
350 fuel pump
Hi, Thank you flatheadyoungin for taking the time to reply you all have been a great help thanks. Bob
- Thu Feb 04, 2010 6:08 pm
- Forum: Late model JD crawler technical support
- Topic: 350b fuel pump shaft seal
- Replies: 8
- Views: 9360
350 fuel pump
Thanks for all your help. Bob
- Thu Feb 04, 2010 10:58 am
- Forum: Late model JD crawler technical support
- Topic: 350b fuel pump shaft seal
- Replies: 8
- Views: 9360
Fuel pump 350 crawler
Ken, I have a diesel model, and its a db pump. I have a manual but when i took it off i pulled the pump and not the shaft so l,am installing the two seals on that shaft. the front one won,t side all the way in without turning over alittle. I thought about pulling the shaft out and taking it with the...
- Wed Feb 03, 2010 8:03 pm
- Forum: Late model JD crawler technical support
- Topic: 350b fuel pump shaft seal
- Replies: 8
- Views: 9360
350b fuel pump shaft seal
I bought a rebuilt fuel pump, i put it back on and the shaft seal keeps getting turned over and then leaks fuel into the crankcase. Is there any tricks to doing this? i have a tool from the pump place that i bought for this , I put lots of lub on the shaft but dosen,t seem to help. Thanks for any in...
- Fri Oct 24, 2008 7:49 am
- Forum: Late model JD crawler technical support
- Topic: jd350
- Replies: 2
- Views: 3172
jd 350 starts than stops
The 350 is a diesel and you are right about the pump as i took it in and they said it had a disenagrated plastic part and repaired it for 600.00. Thank You for replying to my question. BVD
- Sun Oct 12, 2008 8:54 am
- Forum: Late model JD crawler technical support
- Topic: jd350
- Replies: 2
- Views: 3172
jd350
I have a 350 that I just purchased, IT starts up runs good for about two or or three minutes then quits. The fuel filters were just changed but i replaced them anyway, i replaced the manual fuel pump and tried loosening the return line but still end up with the same problem. I'am hoping someone can ...