JDcrawlers Messageboard

First you should NEVER use ether on a 2010/1010..... on the side of the INJ pump there are 2 small screws about 1/2" apart (timing window) pull the cover look for "mouse turds" should only be clean fuel.. crank it over and see if anything turns in there ........ sounds like bad pump ... Pull fuel li...

Thought someone here might be interested http://www.ebay.com/itm/John-Deere-Carb ... SwMtxXtLCN

NOT mine

I bet its a diesel? If it is the umbrella seals on the pump are leaking.... What you drained out was very thin? Went through a lot of fuel lately? I had the same thing on one of my 2010s

I don't know of any way to get trans oil in the engine AND IF you could I don't know how you would ever tell that it was trans oil ??

1500-1800 psi ...... standard guns are 5000-10000...

here is the type gun you need
https://www.amazon.com/Alemite-4015-A4- ... B009K50ZOM

ALSO good reading here

http://www.jdcrawlers.com/messageboard/ ... re+gun+oil

I have told him over the years to get rid of this old stuff you will never use it... and he won't......guess he has the last laugh :lol: Just shows what i have said for years MOST kids and spouses think Everything WE save is JUNK that needs to be GONE ....Some of them do learn after things like you...

Gulia116 wrote: I just changed all the filters drained the tank and reprimed the system, i

I assumed (may be wrong to do so) that with the statement above of the OP that he has fuel flow to the injector pump ..... that's why i said mouse turds

Search.... mouse turds ..... that will possibly be your answer

Looks like the axle is turning in the yoke brackets you need to address that ASAP if it is

Assuming that the grooves are relatively smooth I would NOT worry about them

Most likely 1/8" pipe

IF it steers nice (as in the track stops when the lever is pulled) then the brake bands are OK its between the pedal and the steering housing ... YOU REALLY NEED a service manual if you don't have one the steering/brake adjustment are petty complex and have to be done in a specific order

NOT off of deere at least nothing 2010 or after might be OLDER case I say older because of the BOLT together cylinders

Has to adjust the clutch fingers as they were high, but I would have expected low. Clutch disc is in good shape. The plates has a slight oxidation to them in the pattern of the clutch disk for sitting so long I guess so I removed the oxide layer on the plate. That is the only thing I could see maki...

(DAMN cap lock i did not want to retype all over again) YES YOU CAN GET KEY SWITCH WITHOUT START POSITION but JUST BECAUSE IT HAS ONE DES NOT MEAN YOU HAVE TO USE IT YOU CAN STILL USE A PUSH BOTTOM HELL YOU COULD HOOKUP BOTH FOR THAT MATTER