JDcrawlers Messageboard

I have (3) 2010 crawler hoes and engine plus parts, northeast PA 570-689-9305
Where are you located, and have you resolved some of your issues. Gerald

My name Gerald with three 2010's , engine and engine parts for sale !! Location northeast PA 570-689-9305
Where is your location? May or may not be able to help..

Doing fine, getting older, more couch time. Especially during the winter

I have three 2010 crawlers hoes. One of which is for parts, I do not know if this parts machine will help you.. Right now we are in snow country..

Gathering of the Green, Who's going and is it worth while? Gerald

Not finished but I am getting (indication of) results. I will try to answer all questions/statements and leave our conversation complete.. This is my first power steering learning maintenance,, so much could be added.. Our question of control valve (spool valve) movement (forward and aft) activated ...

Sorry I did not notice your flow control valve open closed position question prior to posting my more info ramble.. The flow control valve is were the pressure hose attaches coming from the pump. Used to maintain some pressure (adjusted to 130 psi at fast idle) WHEN THE CONTROL VALVE IS IN THE NEUTR...

More info, I removed pressure gauge and installed a shut valve with garden hose attached..Eng running pump is recirculating nearly 4gallons per minute.. Put the end of the garden hose in reservoir fill port and continued to run the eng. no air or foaming, solid flow for about 5 minutes. I have concl...

Well last week I "tee'd" into the pressure hose at the control valve and had flow from a garden hose (brother saw it). Now I "tee'd in with a gauge" and no indication of pressure at a fast idle. first gauge increment is 25 psi, should be a minimum of 130 psi with a closed flow control valve. If this...

Yes last week I tied into the pressure hose fitting at the flow control valve to determine fluid flow (so as to make sure I would not be damaging the pump) I did have good flow, however I did not install a pressure gauge. Might be one of my next steps..This morning I took the screw cap (cover) off t...

Thank you for responding..not sure that I should continue this link because time for others is precious.. Yes this servicing and bleeding process has been going on for about 3 weeks, while parked in the extreme turned position and held with a rope on the steering burbing air amounted to about a cup ...

Help desired JD60 power steering doesnot come back to life. Iam addressing issues with this tractor, currently installing new radiator. To accomplish front (grill) and top fairings removed to include the fuel tank. Steering wheel and shaft removed.. With pressure hose, left and right turn pressure t...

Only stating my expeirenence and often to busy for dialouge. I had three engines apart and here goes. Since you have the oil pan off, measure #1 rod bearing, you will find it worn about .008.. Put it back together for now, remove the valve cover and inspect the CORK end plugs in both ends of the val...

As directed in service manual SM2037 ch 40 sec 10 pg 6 CAUTION statment the rear shaft hold down stud (bolt) must be oriented correctly. Page 1 of this section describes oil passage with the flat FLAT oriented correctly..I think the flat is toward the right rear corner of the head linning up with th...

I have extra clutch operating parts for the same reason you spoke f,purchased a crawler with those parts missing, even though the had them availble from a parts crawler. I am 2hrs from the crawler(s) and parts book, so will try to name the parts genericly with out part numbers. NOS lever arm that at...