FYI, I know nothing about them but thought it could help someone here..
http://portland.craigslist.org/clk/grd/3682108996.html
Hope I did that right...
Search found 5 matches
- Thu Mar 14, 2013 11:30 pm
- Forum: Show & Tell
- Topic: 40 or 420 4 roller tracks
- Replies: 0
- Views: 3574
- Fri Sep 14, 2012 6:00 pm
- Forum: Early model JD crawler technical support
- Topic: Blade swap
- Replies: 2
- Views: 4298
6 way blade from a JD 350
Yes, it will fit. I did one years ago and as I remember there was only a minor difference. I think it was where the rear of the blade frame mounts to the crawler crossmember. I think the 1010 was a square bar and the 350 round. I fabricated the mounting strap out of 1/2 x 3 inch strap as I recall.
- Mon Apr 30, 2012 8:15 pm
- Forum: Early model JD crawler technical support
- Topic: Rockshaft Freeing
- Replies: 21
- Views: 17750
rockshaft seal
A speedi sleeve would be another good option since you can access both ends. Replaces the sealing surface with a piece of new metal driven over the end.
http://www.skf.com/portal/skf/home/prod ... lang=en
http://www.skf.com/portal/skf/home/prod ... lang=en
- Wed Mar 14, 2012 6:14 pm
- Forum: Early model JD crawler technical support
- Topic: #35 Ripper
- Replies: 1
- Views: 2596
35 Ripper
I have the JD parts book on pdf. If you send me your email, I will send it to you.
- Thu Mar 18, 2010 12:33 pm
- Forum: Lavoy's Little Shop O' Deeres
- Topic: Looking for info or contact for a 301JD tractor
- Replies: 1
- Views: 2411
301 engine
Someone here might know for sure but I think that motor was also
used in the 1020 ag tractor and the 350 crawlers. Just thought
it might help you broaden your search. Good luck
used in the 1020 ag tractor and the 350 crawlers. Just thought
it might help you broaden your search. Good luck