JDcrawlers Messageboard

Where can I find a 12V Starter complete for a 440IC?

Bendix drive teeth are gone which I can find...bigger problem is rear cover is split right thru oil hole passage...cover in two pieces.

Works good just no teeth left and rear cover split open.
Scott

I currently use my crawler at 1,000' elevation and need to use at 7,100' for a small project.

Do I need to re-jet the carb to use?

Were there any high altitude options offered by Deere?

thanks,
Scott

I have similar problems with the bucket slowly sinking from a full verticle lift to about 90 degrees from the ground where it finally stops and holds in place. Bucket tilt cylinders work fine. How would the raise\lower cylinders (original) contribute to that? I have been told it was probably a cylin...

Looking for a JD engine lift hook or eye.
Attaches/screws to one of the valve cover studs.

Scott

Did Deere ever make a ROPS for the 440IC?

Have seen many different setups and all look different.
Is my only choice to build from scratch?

Scott

1959 440 Gas Loader

Can I replace RH final drive Bull Gear and Axle Shaft WITH OUT pulling final case back off?

Tracks are still off so I have easy access to final case.
Do not want to pull again unless I need to.

thanks,
Scott

Can the axle shaft be removed w/o pulling off the final case again? Assume the bull gear would drop down into the bottom cover if you could do this?

Can the bottom bull gear cover be removed...support the gear...and slip out the shaft?

Scott

Lavoy,

Do you mean locktite the axle shaft splines to the bull gear splines?
What type of locktite do you use...red or blue?

Scott

Just mounted my final drives and sprockets after transmision overhaul. While rotating the drive sprockets back and forth (forward and reverse motion and no tracks yet) I noticed the RH drive had 1" of play where the LH drive sprocket had 1/8". I removed the RH drive pinion bearing cover and the forw...

Appears to have 2 RH steering cases. Did not know they could be switched like that.

Can I reassemble final drives and crawler and replace pinion gear at a later date, w/o tearing down everything again?

Remove Final Drive Bearing Cover and Slide Pinion Gear Out???

Scott

In the middle of transmission overhaul.
Looking for one Final Drive Assembly Pinion Gear 13 Tooth JD# T11031T

Scott