JDcrawlers Messageboard

Lavoy-- do the rubber tracks fit on the stock sprocket and idler for the 420C

I used grade five when I needed bolts for my 420C....never had a problem

I:m sure that Lavoy, the administrator here and supplier of many parts can help you

nice post and pics but I personally would like to see pics of your ROPS enclosure while you are at it. I need some inspiration!

wish I had those tracks!!!

check valve clearances maybe one intake is TOO TIGHT

on that type of chain "the master" is just a pin with a small cotter pin....keep looking

i think it is a venturi..... not a restriction
a true carb part

the correct clutch adjusting tool is a must for new clutch work, as they must be adjusted after bolting up to flywheel
Lavoy (Administrator here) has them

with my 420 I have never removed side frames for final drive service... just as gregjo said I bent a piece of 3/8 rod into a vee shape with two one inch long stubs bent 90 degrees to fit into top two hole of the final and with proper support from above just side out and turn... be careful they are h...

back hoe is by far easier

and don't forget what you said about oil, if the brake is oil soaked ....time for dis assembly

at this point in my life, I always take a photo or two of a project before disassembly................ to help the mind

sounds like the right hand final drive needs adjustment what happens when you pull the right hand lever? if it turns right then left hand final is ok.....

Lavoy.... probably has all the parts you need. he runs this site