JDcrawlers Messageboard

Bob what winch did you put on your tractor series 10 winch I think is a 10 ton . I wished I still had the old woods pto winch from the saw milling days behind my house . Gerald.

There is a lever by the transmission fill an check dip stick by my left foot. That would be powershifter lever. What position should it be in when im working the machine. Thank you Gerald.

Kenp. Thank you for the information on the open an closed loop hyd system.The guy that delivered ithe tracker and hoe for 3200$ said it worked but the hook up fitting was broken. He wanted me to back it off his trailer with hoe not working NO Way he was lucky. I can't repair the hoe unless It's hook...

Matte.Im aussuming eveything will work like it suppose to. I have one out rigger valve that was froze up still sticky , out riggers an boom are the key to connect an disconnecting the hoe "wish me luck". It would be a mess if it fliped over an ripped a hose off or two. I'll strong arm it then hook t...

Kemp I have the 24inch bucket would that make it 95 A? Beleave me i know will it flip ,chained it up to my crawer an lifted the back right off the ground . I figured 2000 lb I should have doubled that weight .Its hard to know what it will do. Its set up close being hook up. The comalongs are holding...

Its strange I can,t find cylinders for the swing. It should work like this 1 on U Tube http://www.youtube.com/watch?v=Nf7QqrrKrmY Thank you Lavoy. It must be a gear box with rack an pinon .

http://www.youtube.com/watch?v=Nf7QqrrKrmY this what im looking for . I have no seat fot it but i have old very nice barber chair im useing with the swivel pedestal off . Brain storm thank you lavoy.

I tryed to hook up my hoe first time today I lifted the bucket up couldn't get under it . I had to lift the hoe up an block the backhoe, don't know if it will work. what is the procedures? i read where some one said it only takes 5 minutes.

Im working on the hoe. I hobe it's a brutte the hyd are amazing 40 year old machine.

I have look evey where trying to figure how to post pictures. Gerald

Kemp.Im going to give it a try now I snapped on how to adjust the steering. It go's like this block the levers 1 1/2 in for slack loosen the leankage nut pull back the retainer clip, slip out the stud an screw in the turnbuckle in, that should tighten the clutches . Will any thing full apart ? It lo...

Im diging into tough mountain the bucke teet are poor an some missing . I would buy used and re build them thank you gerald

When I changed the hyd oil I missed seeing the screen with steal bowl and appartus on top i guss it would secure the screen in place. I stuck my hand in the tank tank of hyd oil to find it only after the hyd almost quit . drained the new oil change i put in last week pulled the paper filter out I th...

I dont get around the old girl much . Im here now and found her in poor maintenance . The bolt for the left track adj was bent right over took the drimal an cut it off where it would set . Im not real shure but it works some way . i dont have my manual with me . The manual explans it all for new clu...