JDcrawlers Messageboard

Jwb. My 350 stright crawer has 23 gpm pump. With the 93 A hoe. I think the small case hoe would be made for open circut hyd sys .

Yup.
The houseing on mine was so diry and greasy an I had to wait for parts like 3 weeks with evey thing tore all apart. Lovy has a sweet deal on the full steering package, ya should replace all parts like though out bearing an pressure p;ate.

Rodger The clutch an brakes are no big deal make shure you put a fiber disk behind the big snap ring the picture in the manual didn't show that. I rebuilt mine a few months back. I never did use the manual to adjust the clutches. move the turn buckle out for the steering clutches it actaivates the p...

I for got to resize the pic Sorry Gerald

I found this not far from my new home for $1100. I couldn't get my wallet opened fast enough. It was set up on a trailer cat that is a small remotecontrol 4 cyll dover for moveing manufactured homes . The owner built 4x4 heavy tubing frame on the back with a seat for quick detatch. I figure about 2 ...

I run my crawer three times a day. It moves alot of dirt . I can get with in inches of my new home being a ground set . It will climb right up loaded with base corse the belly dumps unload . It will take practice to learn the full protential of this machine. It wears me out the more I run it gets ea...

Tjbud. I found when rebuilding my adjuster, the port hole from the sert was gulled closed with iron. I drilled it out. There is a ball bearing under the bleed off bolt with out that it won't take grease .

I know the feeling of lucky, that looked like my Hyd screen befor I cleaned it . that is one reason my 350 was sold so cheep the hyd shuddered because of a cloug filter screen. The machine is parked thinking its broken.

That is true the oil should only flow when the lever is pulled on a open system .I ordered Hoses to extend the hoe for hook up ,it will help in doing checks on it alot easier. Thanks for the thought Gerald. There is a small vent on the bottom of evey valve cap where the spool is pulled from the bott...

Kemp that's to bad. I know what your looking at I was going to pull mine apart when doing the steering work. I just left it with all the slop the nut was tight and bearing was good but its just a matter of time befor I have to go after that ring gear. thanks for the up date gerald.

kemp Your right there isn't much room , wrap duck tape around the threads protectit. I have used dremal with good wheel an cut a good grove or several places brake it with chisel use safety glasses . good luck .

Kemp nice shop to work in . I hope my 350 won't need that kind of work since I sold my house an shop to my son . Keep us posted with good pic. thank you Gerald

I ordered rebuild kit for the adjuster on my 350 simple job it works nice . to my suprise . I said easy well except for one side where I had to put it in a vice and heat the adjuster an pump grease it would only jump out 1/4 inch and I let it set an come back again that went on all day an night. My ...

Inside that valve there are ports when you move the lever the spool lines up with the port your useing . My guess would be to look at the hyd schemtic an find a check valve first then go into the valve to see if there isn't something lodged in that port
or even galled spool in that one area,

Inside that valve there are ports when you move the lever the spool lines up with the port your useing . My guess would be to look at the hyd schemtic an find a check valve first then go into the valve to see if there isn't something lodged in that port
or even galled spool in that one area,