JDcrawlers Messageboard

Hello, I'm rebuilding the generator off of my loader, and the only part left that I need is the bushing on the commutator end. JD doesn't have it and Ebay seems to have a bearing(won't fit), not a bushing. I managed to get it out by threading it(was worn out anyway),threading a bolt/nut/washer combo...

Hi, if you still have your 2010c could you send me a picture of it, and what your'e asking for it? I realize its been a while ago that you posted it but thought I'd give it a try..
Thanks, JB
my email: arxnsparx@hotmail.com

Lavoy, here's the numbers on pump:
16849T
T18820T
T577T
I think the 1st number is the pump casting,and the third number might be the impeller but I'm not sure. Should have been more cautious with that impeller, being cast iron
Thanks, Lavoy
JB

Hi everyone, Well I screwed up, was doing ok taking apart the water pump, got the pulley off ok but broke the impeller when pulling it off.Lavoy, do you have those? I'd like to get the pump kit with it if you have it too... :oops: Note: when removing the impeller, tighten your puller a LITTLE then t...

Hello all, I recently removed the radiator, water pump and generator to do a rebuild and/or clean up on them. Noticed when I took the radiator off, it has what I assume an oil cooler section on the bottom :?: which attached to a horizontally mounted cylinder down in front of the engine. What does th...

Hello everyone, today I have been looking for the serial # on my JD 2010C crawler/loader with no luck. Looked all over the rh corner of the engine block and the Lh side of the bell housing. Even removed generator to scrape/clean behind it. Does anyone know if it could be somewhere else? I assume its...

Ed got back to me pretty quick, he also said my crawler should be 39 links, thought I counted 38. I'll check mine again next week. Tigerhaze, mind if I ask you how much the hydraulic adjusters were? Guess yours were not economical to rebuild?

JB
_____________

JD 2010C loader

Oops, jumping the gun a little bit. I have to find the serial numbers to determine what I need. The crawler is in Maine and I don't get up there too often but I will check next time..Does anyone know roughly what a complete track weighs? I'm looking at a whole track(s) because the pads are worn pret...

Thanks everyone for the info;for grins I priced the track at CrawlerHeaven/Ed, he has NEW ones at $795 per side! I assume thats' not with pads... Lavoy, yes its' a loader and I've been going over a lot of rocks, so I guess that didn't help things

H'lo, I bought a JD 2010C 2 years ago and have been using it to build an access road in Maine. Moved a lot of rocks,gravel,ect with no problems till now, when I'm driving along the tracks made screeching sounds once in a while. To make a long story short found the track on the left side had cracks i...