JDcrawlers Messageboard

Well I was pulling out logs with my 1010 it has a jd 3315 hydro winch on it and got to the landing and it will not free spool. It has the older spool type control, pulled it apart and it looks pretty good inside. So I tested the hydrolic pressure and it was about 800 psi so that shouldnt be the prob...

thanks lavoy I will try that.

Haveing a problem with my 1010 jumping out of 3rd gear. The shifter is on the dash. If u hold your hand on it, it will stay in on flat ground any sort of load against it like trying to turn or alittle hill it jumps out. Any help would be greatly aprecaited. thanks jay

Call this place it's where I got mine they have tons of jd parts pb&h 888-588-3005 they are really good

Yes it will fit. And as for your pto it is an offset shaft. I just sold a 8a that came of a 440 my buddy put it on his 40 worked fine.Jason

I just bought an 8a that came off a 440 crawler. An 8g is the same winch just mechanically activated and the other is hydraulically activated. I just put a 3315 Deere on my 1010 so I think that will work all so. Jason

I have an E3315 winch and it has an oil leak on the dry side aka clutch side. I checked the brake cylinder and line no problem there. This one doesn't have a line for the clutch engagement it is plumbed threw the housing cover. Wanted to know if anyone else has had this problem and what it might be?...

I was always told to run non-detergent in the older machines because that's what they used for so many years. And the reason being is that the engine has a build up of sludge in it, and if you go putting detergent in it, it will loosen all that sludge up and potentially hurt the engine. But if you d...

Yea your good with the original points and capacitor just the coil needs to be changed on the ignition circuit.jay

I just converted mine to 12volt. I like using a one wire alternator then all u have to do is run a wire from alt to bat its real easy. I used two pieces of angle iron on the bottom of the alt about 3 inches long and the original top tension-er. you will have to change the coil and lights but other t...

OK here's the whole story, I bought a 1010 dozer and wanted to put a winch on it. I bought a 3315 off ebay it is is in real nice shape. Got it all mounted on the dozer and took it down to try it yesterday. well at first it didn't have a lot of power found out my spool valve wasn't opening all the wa...

Just wondering if anyone knows if running your reverser with a 3315 winch will hurt the winch? Because it would be changing the pto direction to?thanks jason

thanks lavoy I found it under the floor board!!! You wouldnt by chance know how bad it is to use a 3315 winch with the reverser, will it hurt the winch pump runing backward? thanks jason

My pto on my 1010 wont turn any one know if there is an lever or what the problem might be. thanks jason

I have had some luck drying out oil soaked disks with a little brake clean and an oven. If they are not to bad you can clean them off good with the brake clean and then put them in an old oven and leave the door cracked and just keep checking them, it will dry them out to a degree. well if Ur a poor...