JDcrawlers Messageboard

Will JD 3600 intergal arch fit both a 350 and 450 tractor? It seems I saw brochure somewhere that made be think it would. I need an arch for 450c. Let me know, thanks.

Will the 350c logging arch bolt on a 450c? I think it might based on an old JD brochure/ad I seen on Ebay. Can't seem to make jdparts.com work today...
I need an arch for a 450C soon!!

Thank you all. I'm thinking this 4219 driven non-turbo compressor might be worth chasing. Its very low hours. Also I have a 410 so it would never go to waste. Worst case for the dozer swap would be to drill and tap the block for turbo oil lines and change over the manifolds I guess. smoke screw? Is ...

My 450c dozer has a 4219 turbo engine. Its weak.
I have found a 4219 non-turbo in a 1978 vintage compressor.
Can I install my turbo on a non-turbo engine during the swap? I've heard the term turbo built. What are difference?
thank
Roger

Hey thanks for the input. More information: both the barrel (dog ears) and the rod end are worn badly in my opinion. Almost egg shaped on the rod end. When I first took it apart I could see bushing 360 degrees in the rod end. thinking it was just bushing wear(the pins look fine) I order new bushing....

The arch seems pretty rare at this point. My guess is that there are lots of them around but nobody will to part with them. Keep looking. Will keep you in mine regarding the fairlead.

Looking to buy 3600 arch for 450c.
I have a winch fairlead to trade towards arch if wanted.
Roger

I need a pair of angle cylinders for a 6405 6 way blade? Working on a 450C. Blade was in rough shape. I have repaired and rebushed the c-frame. Replaced the angle frame. Lift and tilt clyinders are good and will be rebushed. The angle cylinders (both ends) are wore badly such that new bushing/pins i...