JDcrawlers Messageboard

Need a set of fenders for my Lindeman. K&K is sold out and is not re-ordering.

I have a very loose axle to sprocket fit that needs to be repaired. They used a pipe for a spacer that fit over the splined axle between the inboard of the sprocket and the tractor housing. Then drilled and tapped the end of the axle and put another spacer on the outboard held on by a bolt and heavy...

ok, let me know the cost when you get a chance

Is there any availability for the TE70 Rubber Bushings for my 1945 BO Lindeman? Is anyone making those?

nevermind, I got them apart today. Removed the other end of the axel from the final drive, took it to a press and used heat and about 55 tons to separate the two.

Any ideas to remove the back track sprocket from the axel? I've tried using the locking flange and 3/4" bolts as a homemade puller and poured the heat to it...still nothing.

All, I am looking for the carrier yoke (TE2462) and right steering clutch case (TE766) for my 1945 BO Lindeman crawler. Mine are welded and I'd take "clean" ones if I can get them. Also looking for a good set of track pads/shoes and three knobs (9001). Thanks, Joe

I'm just getting started restoring my 1945 bo lindeman and am seeking some insight to make things easier. What's the best way to remove the tracks, can I back up the front wheel enough to slip them off or do I need to remove a pin from a coupler section (can't see one that's obvious)? Secondly where...