JDcrawlers Messageboard

Thanks for your patience. I did read other posts.
I wasn't sure if I should ask specfic questions about a past message with a reply. Or make new post.
Rebuilding undercarriage and idlers are borderline..looking for new but seem hard to find..


thanks again

I have OEM idlers on my 350, they are worn. From reading some of the past messages, sounds like I can rebuild them. Are they cast steel? What kind of rod? Is it nessary to preheat? Do they make aftermarket? Any sources out there? From Wisconsin. Lots of questions I know..New to 350's and trying to f...

Thank You..that's what I kind of thought....

Being new to this blog...I realized that I should have been in the later model forum..Thanks again...xeagerx

Greetings..Does anyone know where I can find a used adjuster spring for a 350? Are the springs on some other models the same? Mine is broke a couple of inches from top.
Thanks.....xeagerx

Greeting..I am machining a new piston for the the track adjuster. The new seal kit is different ..My question is ; When I install the back-up ring on the piston ..does it go toward the idler side of o-ring or the spring side? I always thought the back-up went on low pressure side..but parts manual s...

Thank You you are a great help..No movement makes sense ....I'm not sure what Deere was thinking with the bushings..
xeagerx

I have a late model 1968 350 crawler loader. I am repairing undercarriage. Chains, srockets, rollers etc. My question is when I reinstall the track frame to the front cross member , is it normal to have any movement @ this point? The holes in cross member are worn and too large for new bushing. I wa...