JDcrawlers Messageboard

I just rebuilt the engine on mine. Deere has no new pumps, but I did get new shaft, gears, and relief parts through them.

I would llike to replace the cyl block because upon disassembly it looked like the block had been froze up. There are cracks between every cylinder and down through two of the main bearing webs. The former owner had made a patch. A good block may be hard to find, but is of course the best repair. If...

I need a cylinder block for a diesel 1010, serial no. 52163. I took mine apart after piston failure to find lots of cracks. Block casting no. is T17513T.

I recently purchased a 1010 trackloader and would like to find out what year it was made. I found a plate on the front of the hydraulic control console and wondered if this would be enough info. It has a serial no.7481 and a model no. 810. Looking at a service manual for early and late models these ...