Search found 298 matches

by jsal
Sat Jul 20, 2019 10:53 am
Forum: Late model JD crawler technical support
Topic: Oil Level Help
Replies: 8
Views: 124

Re: Oil Level Help

i also have a 350 sounds like the dip stick is the right one if it s a round tube


JIM
by jsal
Sun Jun 30, 2019 4:38 am
Forum: Late model JD crawler technical support
Topic: 450 Fluids, engine manufacturer and paint
Replies: 5
Views: 243

Re: 450 Fluids, engine manufacturer and paint

for the paint just go to a JD dealer get the early construction yellow you do not have to worry about match cheaper than automotive paint reasonably priced also gallons and spray !!!!

JIM
by jsal
Sun May 19, 2019 3:32 pm
Forum: Late model JD crawler technical support
Topic: 350 B Reverser
Replies: 19
Views: 3243

Re: 350 B Reverser

possible problem there is a splined coupling between the reverser and trans that wears out only way to check is take apart may have other problems seeing that it stalls engine

JIM
by jsal
Sat Apr 27, 2019 10:48 am
Forum: Late model JD crawler technical support
Topic: JD350 fuel injection issue
Replies: 15
Views: 2683

Re: JD350 fuel injection issue

you need to clean your tank and blow all your lines out I took my pump apart my self and there was rust from water getting through filters and that is what seized the rotor shaft that broke the drive shaft this was on a 302 john deere industrial tractor

JIM S
by jsal
Fri Apr 26, 2019 5:56 am
Forum: Late model JD crawler technical support
Topic: JD350 fuel injection issue
Replies: 15
Views: 2683

Re: JD350 fuel injection issue

most likely your pump is froze up may need to replace that is what i ended up doing the rotor assembly is like $800.00 with pump repair your at 1200 to 1500 so I purchased a new from JD. I made a wrench to access lower bolt. also on the filters i have found that the JD filters are cheaper than wix a...
by jsal
Wed Apr 24, 2019 5:34 am
Forum: Late model JD crawler technical support
Topic: JD350 fuel injection issue
Replies: 15
Views: 2683

Re: JD350 fuel injection issue

had the shaft my 302 Jd industrial tractor break you need to pull cover on front and remove retainer nut then strike shaft to release shaft from gear as it is a tapered shaft

somehow my timing gears jumped and it was necessary to remove front engine cover and reset gear timing

JIM S
by jsal
Sun Apr 21, 2019 4:35 am
Forum: Late model JD crawler technical support
Topic: steering not working
Replies: 8
Views: 1654

Re: steering not working

the steering gets oil from the reverser i believe not the main pump check your trans fluid


JIM S
by jsal
Sat Apr 20, 2019 5:30 am
Forum: Late model JD crawler technical support
Topic: 450 Fuel wont Bleed after Fuel Filter replacement
Replies: 5
Views: 1549

Re: 450 Fuel wont Bleed after Fuel Filter replacement

thats not possible to fill first assemble and fill with primer lever on fuel pump !

JIM S
by jsal
Tue Apr 16, 2019 1:04 pm
Forum: Late model JD crawler technical support
Topic: 550J Track Tension Adjuster Seals Replacement
Replies: 4
Views: 1403

Re: 550J Track Tension Adjuster Seals Replacement

sounds right another way is to push idler out if you have a porta power brace back to support roller bracket that works better

JIM S
by jsal
Tue Apr 16, 2019 5:05 am
Forum: Late model JD crawler technical support
Topic: 550J Track Tension Adjuster Seals Replacement
Replies: 4
Views: 1403

Re: 550J Track Tension Adjuster Seals Replacement

remove grease fitting wedge a block on sprocket rotate in reverse to move idler back then unbolt adjuster pull idler ahead and adjuster can be removed

JIM S
by jsal
Sun Apr 14, 2019 4:45 am
Forum: Late model JD crawler technical support
Topic: 350 what is it worth
Replies: 10
Views: 2020

Re: 350 what is it worth

Got my no start problem resolved replaced battery cables with new 2- 0 cables soldered ends on removed solenoid and cleaned had to bleed injectors twice and removed air filter to
get the either where it was needed even did some pushing dirt for an hour with the old timer !!

JIM S
by jsal
Wed Apr 10, 2019 7:08 pm
Forum: Late model JD crawler technical support
Topic: 350 what is it worth
Replies: 10
Views: 2020

Re: 350 what is it worth

took my battery tester and checked battery volts cranking 10 1/2 at starter terminal 8 1/2 definite not getting volts
by jsal
Wed Apr 10, 2019 11:49 am
Forum: Late model JD crawler technical support
Topic: 350 what is it worth
Replies: 10
Views: 2020

Re: 350 what is it worth

I have a disconnect on the machine one battery nearly new one is new was started in january ordered a high torque starter from D B electric going to replace positive cable have ground from disconnect to engine not going to be able to work for a few days let you know what I find

JIM
by jsal
Wed Apr 10, 2019 8:03 am
Forum: Late model JD crawler technical support
Topic: 350 what is it worth
Replies: 10
Views: 2020

Re: 350 what is it worth

now that I decided to sell my dozer it does not want to start, turning over very slowly had same problem with my 302 Jd tractor turned out to be fuel injection pump was seized up i ended up braking the drive shaft of the pump drive trying not to do that again ,anyone have same problem ???? JIM
by jsal
Sun Apr 07, 2019 7:52 am
Forum: Late model JD crawler technical support
Topic: 350 what is it worth
Replies: 10
Views: 2020

Re: 350 what is it worth

thanks Jim looked on machinery trader got some ideas may be posting it there

JIM