JDcrawlers Messageboard

Thanks lavoy

I have a Rc 37574 hydraulic lift cylinder for my dozer blade and I was wondering if someone knows where to get a rebuild kit and possibly a rod any help would be nice. Thanks Donald

Thanks for the help guys it was a throw out bearing adjustment

fiber disc are fine steel disc had light rust. over looked adjusting throw out bearing. going to try that tomorrow

When i say only right track turns I mean the right track has power left track turns freely but no drive to it.

hey guys i cleaned up the steering clutches to left side and put back together. it worked great for a few minutes now there is no power to that track. i put blade against a snow bank and only right track will turn. is this a adjustment problem. need advice

Oh and I also installed a new inline fuel filter in the fuel line ( and correctly) would this be to much restriction?

OK guys I will tear down and do a try this again taking much more care and detailed job. Thank you so much for your advice. Rest of tractor is complete and I guess I was hurrying a little to try this thing out.

Lavoy I put the basic kit in. Clean and blew all ports out. Going to checkout throttle shaft for wear next. Adjusted float to proper height. Cleaned complete fuel system. If I pull choke very slightly it will smooth out. Any tips for me!

OK thanks it will smooth right out if I pull the choke out just slightly also really appreciate you help

looking for some advice. Rebuilt my carberator in 420 crawler and now i cant get engine to run smooth . it surges up and down. It is a little better with more throttle and worst at idle any suggestion out there would be helpful

no flaking oil or damage look in real good shape was new before we parked it .only thing would be swelling but all look good. would built up surface rust on steel disc do the same thing as disc swelling.but your right is it all worth saving money. just was all new before we parked thats all. and wor...

how do you know if disc are bad. they look dry and in good shape. what is the thickness of them. can some one give me an idea or should i just go new. thanks

thank you very helpful

does any one know where i can get a break down or service manual to help me replace steering clutch on 430 crawler