JDcrawlers Messageboard

That is too funny, as a manager in the past I can relate.

JT

Now that you say that the inboard ones do look like bleeding nipples. Glad I didn't try and grease them lol.

Thanks
JT

Thanks for the info

JT

I have a JD 310A and while tearing into it to replace the hydraulic pressure control valve o-rings I discovered 4 grease fittings on top of the rear axle. One by the outboard bearings and one on either side of the transmission. Any idea what kind of grease and how much I need to put in there? Thanks...

Richard, thanks for the info. I was just assuming it was like my JD 310A. I went out and looked close at both of them and I see what your talking about.

Thanks
JT

Does anyone know where I can get a lift cylinder for a JD 350 6 way blade? One of mine the packing nut just spins and won't come off or tighten up.



JT

jsal wrote:Might want to pull plugs out and check lube in them just a thought
JIM

My plugs would not come out...

JT

Here is a photo of the rollers. Note they do not have bolts to hold the axle in nor do they have grease fittings. http://gnipsel.com/images/JD350B/rollers.jpg JT I have a 350B with no fittings or plugs anywhere on the rollers or shaft that I can see/feel. Can't see your picture which might tell me ...

Thanks, as soon as monsoon season is over I'll give that a try.

JT

I assume you need to block up the crawler end of the C frame?

Thanks
JT

Checked the cylinders and the rear bushings on both are a little worn. The C frame bushings are loose for sure. The C frame is the part that connects to the pins under the crawler and the whole 6-way raises up and down with? What do you have to do to get that bugger out and fix the slop?

Thanks
JT

I finally had a chance to use my 350 the other day and was trying to skim off some dirt that had collected on a flat area behind my shop. Seems like every time I lowered the blade down after a few feet of pushing dirt the front of the crawler would rise up and the blade would dig in. Am I just doing...

If your talking about the pre-cleaner I just ordered one online from apartsdepot.com Donaldson H001250

JT

This video shows them using a magnetic drill.

http://www.youtube.com/watch?v=ZB7ba36BoNk

And I have one!

Now to figure out what rods they use to weld up the holes.

JT

Got a photo of the boring bar?

JT