JDcrawlers Messageboard

Had a 350B yrs ago with 30" pads. Was just a 6way blade machine. Would practically walk on water. The pads on it were stating to fatigue like the picture so we added a Second grouser to each pad. Really stiffens them up, and flattened them back out. We would use it for maiming slope work placing top...

Nice chart for undercarriages. Glad that mine is practically new. Have to keep my eyes open for some 12" dozer pads tho. Only half of Mine were replaced with new. Other half is worn street pads. If I can't find some I'll just weld hardox on for grousers.

I'm just learning capabilities of parts on these Machines but does anything from the 1010 crawler bolt up to the 440s? Like a Dozers frame or finals or pto or such?

Thanks, keep me posted.

Well I don't know if I could scrap it that's harsh. Itll probably go to farm and get stacked in shed with dad old iron.

Ok I have my 440IC crawler with a 91model loader. What is the loader worth with 5.5ft wide bucket. worked when I took it off. Just leaning twords an inner C frame and blade.

Thinking of selling it or maybe trade it. Any input or thoughts is great.

Well I went through the carb last night, new points, coil hooked up a 6v battery I borrowed from dads 49 A and my 440 fired up. She just sat and purred. What goodfeeling it was. I'm hoping to test drive it today. I know there's things wrong but hoping to figure them out today. When I try to drive it.

Ok I've got a question, by looking at my crawler it has the pto lever on the left side on trans. It has the cap on the rear where pto would go. What do I need to have pto. Obviously the shaft and bearing housing that bolts it place of the cap. But can I literally slide it in and go? Know for the oth...

Found the tag, after scraping a healthy layer of geese and dirt. 442728

Thanks Paul! I'm not sure what I'm going to do for sure with my toy. Its more or less a connection between my childhood farmboy experices and my adult profession. It's a Combination of our 2cly tractors we have on farm and what I do everyday of the week working on and operating equipment. Next time ...

Thanks! I'll take a look to see if I can find that serial tag. And i agree about cost of building blade. Just checking if anybody has attempted it before and results.Hoping today to tinker abit on carb and clean gas tank and such. I really wish this rig had a 6way hydro blade but I can't complain fo...

I have many hours on TC 550G LGP through my work over the years. Wonderfull dozer for finish grading! we have since upgraded to a CAT D5K LGP. We have a 455g loader TC on our family farm paired up with A 450G with direct drive. As far as just pushing dirt or clearing fences either one are great and ...

Well the loader is all off except the steel hydo line runnein under belly and up to each side going to drop belly pans today and remove them as well. I know I'm going to find issues with this rig the deeper I get. However the under carriage looks like it had major work done with few hours of run tim...

Im a newbie who just hauled home and started tearing down a crawler. As I know it has the gas engine, 5speed trans, and reverser. It's equipped with the model 91 loader and 6ft blade but also getting the 5.5ft dirt bucket. The issue is I can't find the serial tag on the tractor. The loader tag is on...