JDcrawlers Messageboard

Hi,
Will a 1010 loader fit on a 420?
Dennis

Well, I got the steer clutches off on the right and two of te springs were off by the thowout bearing, and there was a sleave over the shaft that was being chewed up, what is te purpose of this sleave? Alos I pulled the pressure plate off and there are two fiber plates right under it and on broken o...

I saw in the last post that you sell the manuals, how much are they and how do I pay?(as helpful as you have been if you have one I would be an idiot to buy on somewhere else)
Thanks
Dennis

Hi,
Does anyone know which manual is better, the IT manual or the John deere one?
This is where I found each one:
IT
http://www.agkits.com/index.asp?PageAct ... ProdID=283
JD
http://www.jdheritage.net/DeerelyDepart ... s/2047.asp

Well, I just got home and pop goes the right track. Does any one know where I can get a repair manual, and any hints to put this track on would be great. The master pin is on the top right after the drive sprocket.
Thanks,
dennis

Well I purchased a 2" one on a guess an it was to small, it fit inside of the straight pipe. Also I am sure there is a reverser on it, which means am i supposed to add oil to the fill plug on the left side under the gas petcock?
Dennis

It does have a lever on the right that puts it in forward or reverse, also does any one know the diameter of the muffler?
Thanks,
Dennis

Thanks,
What are the two plugs on the left side just about under the gas tank on the tranny?
Dennis

Hi, I just picked up a 420 crawler yesterday and it starts and runs great, here are a few issues I was hoping I could get help with. The first, i pulled what I think is the tranny fill plug on the left side and I an not touch any fluid. Does any one know what it takes? The idlers need bushings, wher...