JDcrawlers Messageboard

Actually had the brake band resurfaced. Not sure on where my mechanic obtained the clutch discs

I’m quite certain that it did. Initially we adjusted it when it was hot and sticking and after we adjusted it we did a small test run and it seem to work OK.

So I had new steering clutches and brake band put in the left side of my 350 B. Right side was fine and was replaced earlier. Seems to work great until it heats up and then the brake band is sticking. You can actually smell the break band. Causes some very loud squeaking noises and actually bogs the...

So I am putting the second set of clutches and a new brake band on the left side of my 350 B. Had it done about three years ago and I put less than 100 hours on it since then. Pulled the final drive out and the clutch plates were all rusted up. Question I have is the drain plug that's in the bottom ...

I have a question that i have been trying to figure out. Have a 350b with reverser that seems to work fine going forward but is Very sluggish in reverse. It works sometimes and does t work sometimes. When it does work it has little or no power and will barely move the tractor. Does not have enough p...

3 cylinder diesel

just trying to get a value of a running 350b engine. I currently don't need but would not mind having a backup. The owner states that the engine runs but burns a little oil. Any thoughts would be appreciated.

sorry about my choice of words. You are correct, it is not a engine problem but a drive train issue. Power is not getting to the tracks as it should. Drives around fine but when put under a load, just seems to stop moving and engine does not lug at all. Can you give me any pointers on the best place...

Bought a 350b crawler for working In the woods (has a log arch and winch). Decided to move some dirt and small stumps. Found that when I put the dozer under a load (against a stump) it would just stop. Didn't bog the engine. Just seemed as though something was slipping. Would not even attempt to spi...