JDcrawlers Messageboard

Hello
I need my memory jogged regarding tracks. Will 40 tracks fit on my 420 4 roll? Plus or minus a link?
I have a chance to buy a good set and my 420 tracks are tired.
Thanks
Dan

Like Chevy Chase in "The Invisible Man"

Hello My clutch and brake pedals are frozen together. I have a pretty good idea that I am not the first to have this happen. I am sure that there are a lot of good ideas out there to get them working independently again. I would like to work on this tomorrow. I have oxy/acet if needed. Thanks for yo...

Hello

Can someone tell me what is being used(if anything) as a replacement seal for the front idlers and rolls?? Just can back from the JD dealer in shock.......$246.00.......just plain nuts.....I would prefer to be unsupported by Deere than treated like an idiot...

thanks everyone

Thanks Lavoy

Is the ctr to ctr of the pins on a 2010 the same as the 420 / 350....5.75" ?
I realize that the sprocket offset probably is different but I can machine out the center and weld in another.

thanks again

Hello There is a brand new / old set of 2010 sprockets for sale nearby. The picture shows the hub bolt pattern and it appears the same as my 420....6 holes for bolts and 3 stud holes. Did 2010 have the same pitch track as the 420 and would the bushing OD be the same as the 420 or a 350?? thanking ev...

Hello

Will 2010 sprockets interchange on my 420 or are they made for a larger bushing like a 350 sprocket?

thanks again

Hello
What is the OD of a new 350 track bushing?

thanks Danny

Hello again
I have read here that a new track has a ctr to ctr link measusement of 5.75" pin to pin.
I am measuring approx. 1.550 OD on the bushing. Can someone tell me what the new bushing OD spec is?

Thanks again

The tracks/links on my 420 are pretty much gone. I have read here that 350 tracks will adapt if I use 350 sprockets and mate the center of the 420 sprocket to a 350 sprocket to get the correct bolt pattern and offset. Will the 420 idlers and rollers work with the 350 track and is there any other kno...

Just ordered a steering clutch tool from Lavoy. Can someone send me the link to the page that explains how to use it to adjust the clutches?
I'm a good mechanic but fall way short with computer searches.

Thanks a lot everyone

Thank you very much for that info.
Have you ever built up the seal area of the output shaft?
I was thinking spray welding. What are your thoughts?

thanks again

Hello I have found spherical tapered roller bearings on both ends of the drive shafts leading out to the sprocket but regular tapered bearings on the upper pinion shafts. My question is: Has anyone that has rebuilt their final drives gone to the Timken 390A regular tapered roller bearing? and has it...