JDcrawlers Messageboard

Jason, so I ended up getting 10inch 5/8 bolts, and separating final drive from dozer, I was able to get my small hands in the gap, remove all of the clutches, and get snap ring on, it was hard and ended up holding with one hand and using closed end on a wrench to pull ring open while using other fin...

Yep, lol..I actually watched that video 20 min before deciding it was silly to install the clutch drum on the roemoved unit and a lot easier to just install it on to dozed...once I noticed snap ring I understood why...I just did t wanna have to tear down again

I'd 350 dry clutch

Hey guys, so I wondered why you had to put the clutch on the outer unit, and not just do it the easy way and put it on the dozed first and not fool with the brake band..SO...I put everything put back together except drive wheel and track and I found a snap ring on the track...and realized it was the...

Oaky fellas, I'm posting a follow-up..So I replace the fuel lift pump, tada..same problem.. So, I ran a hose from the suction side of new left pump into a jug of fuel, and walla, it wored..ran fine..so that told me the problem was between tank and lift pump. So I took off the fuel line at tank then ...

Okay, well I do believe it is the fuel pump, thanks Stan and everyone else that assisted. I ended up bypassing the pump and filter and ran a line straight to the injector pump and into a jug of diesel...bingo..dozer ran, even at full throttle and did not die at all..So I'm ordering a new pump, found...

Stan, So the vent in the tank was plugged, I unplugged it, and still had the problem. But I think that it may have created that vacuum you was speaking about and caused damaged to the fuel lift pump. Does this sound plausible? I started the loader again and while it was running I went around and too...

Thanks, I will check that. Any ideas on the air?

Thanks Tiger, yeah I read that thread..several times, lol..Now, from my knowledge isn't that pump lever suppose to have some resistance? im not sure if that's whats causing what I will call "air lock" but I have no idea where the air is coming from..

67 people have looked at this and no one has a suggestion/answer lol..not even a winger.

Okay guys here's where I am at. So I got the loader started, let it idle for a while then drove it about 500 feet to house, as I was going to park it, it began to kinda starve for fuel, I got off and pulled the return line at bottom of pump...fuel ran out but nothing happened, still sputtered then d...

No, I actually have t checked anything yet, was wanting to get some guidance on where to start, lol..

Okay guys, my loaders acting up. It starts fine, runs for about an hour maybe more sometimes, then dies..and wont start for several hours. Sometimes I will accidently hit switch and kill it and it will not restart for hours. Like it gets hot and shuts down. I have the CBC331-6AL pump on it, so I kno...

I was loading gravel and filling in French drain, the dozer was running fine, I had dropped a load and was going back for more (the pile is 70 feet away) and I decided to change from 2nd gear to 3rd gear, once I got to the gravel pile and scooped a load up, I was leaning to the left to see and my kn...

yeah me too Stan..btw I was wrong, the funny thing is the side with the grease is the side that drives perfectly, no noise, clutches fine brakes fine..its the left that's a mess..that wrrrrrring noise when your turning..it starts out fine then seems after it warms up it goes to pieces...no worries n...