JDcrawlers Messageboard

Yes I put new Deere injectors in it.

The pump that was given to me was off a 350b and I’d like to try it on my straight 350.

My 350 runs lumpy and the injector pump leaks. I have already installed New injectors and I would like try swapping pumps with a stanadyne model JDB331al2405 that someone gave me My machine currently has a Roosa master model DBGFC 331-13DH pump. The ultimate question I have is the stanadyne compatib...

I have a good gas block that just needs rebuilding. The crankshaft needs to be ground and I took it the machine shop. They say they might be able to recondition it. Already ground .010 and hopefully they can get it ground with .030. If not I have to buy a crankshaft and they are scarce. Used ones ar...

My 350 gas dozer needs an engine I have a gas engine from a 301a for rebuild but the cost of rebuilding the gas 3.135 doesn’t seem worth it to me. So I found a 1020 diesel wheel tractor in a junk yard. My question is will it bolt in to my 350 and is it the same horse power as the 3.152 industrial ve...

Will a gas engine from a JD 301a fit in a JD 350 gas?? Thanks

I don’t have a pto but I do have the lever on the floor board. I see that the drive shaft (t21346) is not easy find!

Yes I see the coupling is available through Deere, but do I need the input shaft to go into the transmission or does the winch only require the coupling to go from the winch to the transmission?

I found a winch I"m looking to buy and the guy says it is missing the spline coupling.What parts are required to attach the pto to the winch? Does anyone have a parts breakdown of this section and is this part available? Thanks

Original possum I’m from south Jersey.

I am looking for a winch for my 350. I have found both models (3310 & 3315) and was wondering if anyone could describe the differences between the manual and the power winch. What are some pros and cons and does anyone know if one is more reliable than the other. Thanks

Hey guys I have a 350 Diesel engine question. When I start the engine it sputters for a few minutes and smokes blue. After warm up I throttle it all the way and the smokes clears. Running at full throttle and load there is no smoke and runs pretty smooth. After it gets hot I idle back down and I get...

I guess I did pretty good. I got them for $100 each including the yoke.Score!!!!!

I found a parts 350 in the local salvage yard and I was wondering whats a fair price to offer for a pair of idlers. these are in very nice shape. Thanks

Hello, does anyone know if there is a gasket between the final drive housing and the steering clutch housing on a 350? The parts diagram shows nothing. Should I put some rtv there or is nothing required. thanks!