JDcrawlers Messageboard

Will this include a 350b? If so when do you anticipate having parts? Thanks!

Sorry...It's a JD 350BE My son found the yoke and bought it on BrokenTractor.com. The seal kit that he bought is the only one they listed for the 350b. He didn't do enough research and we ended up with the wrong seal. The seal we received came from Bulldog and is a JH-BD-905000 Their part number for...

Well I broke the track adjuster Yoke (cylinder). It split in half. Not sure why, I would think the spring would give enough to keep from putting too much pressure from the piston on the grease, but I don't know....IDEAS? (Just so I won't do it again). Real problem is I bought a new yoke but I have t...

Twisted the gear shaft stub off today and need to replace the gear shaft in the pump or rebuild the pump or buy a reman pump. Anyone know where to find parts? Thanks

Well, the 350 stopped all hydraulic operation today. Upon investigation i found the stub shaft coming out of the pump twisted in two ( or more likely worn in two ). Does anyone know where I can find parts to rebuild the pump or at least a new input shaft? Thanks

All of your help was great. I put the plug back hand tight then backed it off a couple rounds. Used the blade and a pipe to apply pressure to the idler bracket. Tapped every so gently 😉 with a large sledge on the ram and grease came out the weep hole. An hour of pushing and tapping and the idler was...

Thanks for all the replies. I took a pipe between the six way blade and the idler and pushed. The idler will slide back about a 1/4 inch compressing the spring but no grease is coming out of the zert hole or plug. Can’t find the check ball??? Is it under The plug? Shouldn’t it come out with the grea...

I pulled the plug and the grease zert both if that’s what you mean by releasing the pressure/tension on the front “idler” ( do you mean the front wheel?). Is it called an idler? I always called it the front wheel. 😁. I can’t get it to slide back. That has to happen for me to get the track back on, r...

Track came off to the inside. I have tried a come-along on the front wheel to slide the tensioner but it doesn’t move a bit. Any ideas on moving that front wheel back? Track is wedged under the crawler. The master pin is on the bottom...of course. Any advise is appreciated

Thanks. Been on vacation back at it
Now. I'll give that a try!

This may seem quite simple but is there a trick to replacing the lower Radiator Hose on at 350 b? With the grill out I can "feel" the hose clamp on the Radiator, but no way can I get on it to loosen. Does the Radiator need to come out just to put the hose on? Thanks for any advise in advance.

I have a 74 JD 350b dozer and I have read a lot about a screw that "adjusts the flow" to the reverser. Can anyone provide an exact location of this screw? a picture would be really great. New to the Dozer world, and loving it. Replaced both Steering Clutches already. I think I need a little twerk on...

Is there any reason the axel will not come out of the differential side?[/list]

Ok. Replaced fiber and steel pates. Adjusted pressure plate finger to correct
Height. Repaired throw out bearing linkage and adjusted per repair manual. Seems to be working great. Hopefully longer than the previous repair. Thanks to everyone for their help and advise.

If the clutch failed to release and the brake was
Applied could this destruction result?