JDcrawlers Messageboard

An update to my request for thickness of gaskets on bevel gear bearing quills. I made my own(.029 thick) will allow that for ea side. Also when i went to install power shaft ( 5 spd trans ) to set up pre load, found cluster gear would start to seize, removed all gears from this shaft, reinstalled an...

I have a set of .010 under, new main bearings, from my 440 jd. Had extra. Will sell trade as long as someone can use them.
Send me message to. scork@ goldcity.net.

On a 440 ic- 442172 bevel gear bearing quills, does anyone know how thick the original m811t gaskets are. If I knew that, it might save me from removing the side bearings one more time.
I am rebearing the bevel gear assembly( actuall the whole transmission)
Thank you

I have a set of rod and main bearings, they are from my 440 ic gas, they are brand new, i ended up with 2 sets for my rebuild.
I will check tomorrow and see what size they are, maybe you could check and see if they are the same for a 440 gas, and your 1010?

Sounds like a fuel problem. Yes filters, first. Next plugged line etc. Fuel cap breather hole plugged ?

Maybe drain left hand final drive and see if there is any chunks of metal come out. Have a low walled drain pan that will hold about 1 gallon. Not sure how much oil for sure, but 1 gal is close. Maybe drain right also( in a separate pan) so you can see each and keep them separate.

Am very happy to hear it all worked out for you.

And welcome!

Contact Lavoy on this site, he has a JD store and repair shop.
Maybe post on section “late model JD “ for your needs and help, on this site.

Stan, thanks for the list( that takes a lot of time) I have that SM- JD 2037 for 2000 series machines, and I don’t see that number in your list?? It is a JD publication and came with my 440ic (442172) when I bought crawler. Don’t know why previous owner had it with the 440ic manuals, parts, service,...

Yes. Some valves are like that

That sounds better! Yes install the washer and your 3 thin shims, then let us know what your pressure becomes!

Is that washer thicker than .010”? The thin washers are .010” the washer should be close to .050”.

You will find problem. I think with hyd systems acting up, right after someone that shouldn’t have been working on the system, because of lack of knowledge, is like playing with a jig saw puzzle with pieces missing or in the wrong spot! Proper parts books, and shop service manual, put all jig saw pi...

Ok. Good luck