Search found 7 matches
- Mon Jul 27, 2020 5:38 pm
- Forum: Early model JD crawler technical support
- Topic: 2010 injection pump
- Replies: 7
- Views: 5513
Re: 2010 injection pump
Injection pump and injectors were just fully rebuilt at a reputable shop. Problem exists even with piping between intake and oil bath air cleaner removed so that's not the issue. blew air through all the lines while everything was apart, and fuel flows freely anywhere I take a line off. I do current...
- Sun Jul 26, 2020 6:43 pm
- Forum: Early model JD crawler technical support
- Topic: 2010 injection pump
- Replies: 7
- Views: 5513
Re: 2010 injection pump
update on injection pump, Had Injection pump and all 4 injectors rebuilt. aligned all the marks and reinstalled pump and injectors and new glowplugs. got crawler to start but was running rough and throwing a lot of white smoke. Rechecked alignment marks after it cooled down and marks in pump were ab...
- Fri Jul 03, 2020 12:03 pm
- Forum: Early model JD crawler technical support
- Topic: Pallet forks
- Replies: 2
- Views: 2764
Re: Pallet forks
Thanks Lavoy for the reply, you are correct. I went for a ride this morning and measured them and the pin spacing was off 1/4 of an inch. Disappointing they changed them just enough they wouldn't work without a lot of cutting and welding
- Thu Jul 02, 2020 6:54 pm
- Forum: Early model JD crawler technical support
- Topic: Pallet forks
- Replies: 2
- Views: 2764
Pallet forks
Would anybody know will a set of pallet forks off a JD350 fit on a 2010C?
- Sun Jun 21, 2020 5:10 pm
- Forum: Early model JD crawler technical support
- Topic: 2010 injection pump
- Replies: 7
- Views: 5513
Re: 2010 injection pump
yes, getting pump and injectors gone through. I brought this thing home and messed with it for a couple hours replaced a few fuel lines and filters and drained all the old fuel out of it and did get it to run poorly for about and hour or so. When running about 3/4 throttle and you slowed it to idle ...
- Sun Jun 21, 2020 3:04 pm
- Forum: Early model JD crawler technical support
- Topic: 2010 injection pump
- Replies: 7
- Views: 5513
Re: 2010 injection pump
Thanks jim for the reply, after I posted I pulled valve cover and #1 glow plug and barred engine over until pressure stopped against my finger. I now have plain line in inspection hole, and mark on pump is visible but not centered. This should be close enough to now remove pump correct? I have the s...
- Sun Jun 21, 2020 1:03 pm
- Forum: Early model JD crawler technical support
- Topic: 2010 injection pump
- Replies: 7
- Views: 5513
2010 injection pump
Just bought this crawler and trying to find tdc to remove the injection pump for a rebuild. Flywheel is rusty and having trouble locating the D/C stamped on the flywheel. I found the 180 stamp and barred crank over another 1/2 a turn and I have found another line on flywheel where I think D/C should...