JDcrawlers Messageboard

I am assuming initial settings would be different given the different manufacturer. Are the jets the same?

Unfortunately, there was no manual with the new carb so I have to question whether the Zenith works the same re screw in for lean or out for lean?

I had to replace the TSX777 on my 440IC with a new Zenith 14997.

Has anyone else done this? If so, what did you use for initial carb settings?

Peter Kuzyk
Thunder Bay, ON

I have a TSX777 on my loader that I need to replace. This seems to be impossible.

I had heard that these machines came with a number of different carbs.

Can anyone tell me what my options are? Some TSX models seem to be easily replaced....

Peter
Thunder Bay, ON

My local shop gave me the numbers but couldn't get through their supplier.

Does anyone have a source that will ship to Canada?
I need one set of Clevite CB436B or Federal Mogul 2210SB - either one at 20 thou over

Peter

I was afraid someone might suggest that but perhaps that is better news if oil pump parts aren't available.

Just in the middle of rebuilding the carb and then I think I will move it to a good spot for dropping the oil pan and having a look at the bottom end.

sigh

Thanks for the link. I had found it in my search but was not clear on whether or on the tool was still required.

Will give this process a shot!

I have recently acquired a 59 440IC. It has dealt me a few blows, but so far, no Knock Out punches. My latest problem, under load, I hear bottom end noise and "bouncing" of my oil pressure. I am considering dropping the pan and have a go at an oil pump rebuild.....but.... I see in the service manual...