JDcrawlers Messageboard

So upon rebuilding the right side final drive on a 440icd. I found the splines on the bull gear are worn and chipped. I’m trying to find a replacement gear. The axle has already been replaced at some point. The part number on the gear is m2364t. It’s a 55 tooth gear. The part number in the parts man...

What does it take to switch to Mitsubishi tracks?

The bushings are worn clear through. I can see the pin inside. I’m assuming the pins are also worn out if the bushings have made it that far. I haven’t measured the links. The pads aren’t bad. I just tore the right final drive apart to rebuild it and found the tapered splines on the bull gear are ch...

I read that the sprocket has to be rerimmed to run 350 tracks. How would I go about this? Or would I need to given the sprockets have some wear as well.

I’m working on getting my grandpas 440icd going but the tracks are shot. They’re worn through the bushings and into the pins. Does anyone know where I could find a new or less used set of tracks?