JDcrawlers Messageboard

bypass valve was removed and checked all good.. i was super careful with those o-rings on those tubes... I hope its not that. IE: R&R reverser...ughhh

will have update soon..

dozer did not move due to seals and bearing bad in reverser when bought. I restored with all new parts etc engine runs great reverser new clutches and bearings and seals. tranmission gone thru all good. tracks not installed nor sprockets put back together. oils etc etc on the reverser. I have checke...

has anyone found a decent replacement for the black plastic grips on steering levers >?

i got it off heat and air hammer now working on the clutch lever slow going for sure,,

on the left side steering clutches.. the brake lever riding on the steering shaft. i see that is uses a snap rings to hold it in place i have removed it. but still cant get the brake lever to slide off shaft.. i know the steering arm has a woodruf key and set screw. should'nt the brake lever slide o...

found the leak. front seal and bearing Shot rear seal fell out while removing reverser.. onto total rebuild of it..

thanks everyone

74 350b. new to me still working out the bugs to use. starts fine. when moving forward or backwards, i have a fluid leak underneath the reverser and out of the little vent hole on bottom of the transmission, leaking from under reverser maybe from the small cover on the adjustment screw. thought it w...

1974 350b dozer. no pre cleaner was on it when bought. found one of the bowl types for it but question is what goes inside to make it a "pre cleaner" ? thanks