JDcrawlers Messageboard

I have a ripper set up on the back of my 350 B. Has anyone ever seen or had any experience with a root plow setup that could be installed in place of the ripper shanks rather than removing the entire ripper, which is somewhat of a chore?

So then the clutch pedal would disengage the reverser clutch packs as you put it in gear, would that be correct? What is the free play on that pedal supposed to be?
Matt

Sorry about the double post.

In first or second gear my 350B seems to push and work fine, both forward and reverse. In third gear under no load it takes a second to start moving when I push the power reverser forward. I don’t have much need for 4th gear, but when I put it in gear, and push the reverser lever forward, nothing ha...

In first or second gear my 350B seems to push and work fine, both forward and reverse. In third gear under no load it takes a second to start moving when I push the power reverser forward. I don’t have much need for 4th gear, but when I put it in gear, and push the reverser lever forward, nothing ha...

Got the right steering clutch put back together and the track connected so it’s time for my 350 B to go to work. It now turns left AND right. Going forward everything sounds good, hit reverse and I get the “whine”. It sounds like a hydraulic pump maxed out on steroids or more like the howl that the ...

Actually, I’m wondering if a squirt of silicone on each end would keep it in place. Every place else it’s not supposed to be, it’s always super hard to remove

On my 350 B we had to take the track apart to overhaul the steering clutches. Could not find a “master“ pin so we picked one pin, heated it and drove it out with a steel drift and lots of pounding with a BFH. So far so good. We did the work we needed to do and got the track to realign using a heavy ...

When I bought my 350B the seller said he used to have some plates that bolted on the bottom of the blade corners, but he did not know what they were for, so they went into the scrap pile and disappeared. There is a 2 hole bracket on the back of the blade, at each bottom corner, which is where they w...

Thank you for the quick reply. I knew serial number listing with probably here somewhere. I guess I was too anxious to look around. I will be unloading it off the trailer shortly. I have already found a lengthy thread on a steering clutch release problem that sounds like the only existing problem th...

I just got home with my newly acquired 350BE. Ser # 146106T Where is the best place to buy parts, service and operator’s manuals? Can anybody tell me how to decode this serial number so I can figure out what the model year actually is.
Thanks, Matt