JDcrawlers Messageboard

Also check your shaft bushings if they are wore that can cause it also

Nice

If I paid the same she might be allright with it but the money you paid for that I would be done

I was expecting something expensive happening he had some guts

Thanks

have new pads on some rails that seem the pins and bushings are wore a little but have really good pins and bushings on another set that the pads are really sloppy so should I change the pads or will they just come loose on the other rails or should I just change the hole set of tracts rails and pad...

Just so you know the shaft on the mt is longer then the m or mc but if you find one that you take off the shift lever which would be the same on either tractor it's pretty simple other than a little ball that you have to be carefull not to drop in the tranny

Is there any place mice could have gotten in there ( timing hole cover not in place) they can cause headaches

You have to stay on your toes just when you get comfortable working on them something bites you in the ass just got done tearing mine back apart after putting in a tranny reverser and finals back on found out the splines were stripped in the ring gear so it had to come all apart again thought about ...

I'm bad about taking pictures but talking about stupid when I rebuilt the tranny a few years ago the ring n pinion where in really good shape so I left it alone now I have both finals on put a bar on to check out the adjustment on the brake n throw out bearing got the right side adjusted went to the...

So was getting ready to bolt tranny to reverser and realized the brake pedal was stuck to the clutch pedal tried every thing to free it up spraying pb and others leaving it set over the weekend nothing worked forgot to try water finally put as much heat as I dared without getting the seal to hot kno...

tried to pull just the trannyagain and couldn't get it over the hum so loosened the reverser and it allmost fell out the shaft going from reverser to engine clutch stayed in the clutch will have to open the reverser up and look in there when I get time but that wasn't good right now working on chang...

Thanks

I think I will try to unbolt the reverser and pull it with the tranny. I think something broke in the reverser so maybe it isn't letting the shaft pull out like it should and yes I did remember to block the front. Fortunaly I have another reverser that is rebuilt but unfortunally it is in a small ho...