JDcrawlers Messageboard

ok, thanks, thought so, Its adjusted correctly then,

how would i adjust the clutch? When i look at the manual, it only speaks to adjustment of the pedal. I will look at the manual over again

i got everything adjusted according to the manual, and there is a big difference now, However, I took a small cover off the side of where the clutch is, I think its to grease the throw out bearing as there is a grease nipple there. however when i looked inside with a flash light i notice there is lo...

thanks for the info, You provided a lot of information on diagnostics, that once you explained it to me, makes perfect sense. I will try it tomorrow and hopefully I can solve this riddle.

I am having a real problem with this old beast and I know there is a fix, I jsut need to get there, I have adjusted the reverser as directed in the manual and now got it adjusted perfectly. The steering clutches are all good too and the final drives have been rebuilt, with new clutch plates and disk...

thanks Gill I will give it a try today, In regards to the handle being in the right position from the dash panel. The manual I have shows the lever should be 2" to 2 1/2" past the dash panel when the lever is in reverse. I forgot to block the clutch pedal, I will read and follow the instruction with...

i am trying to adjsut the reverser on my 440 icd and I am having some problems understanding the directions in the manual i have do i first adjust the rear clutch pack, that is on the same side as the lever? When I adjust this clutch pack to get the desired 20 to 25 pounds of pull the front clutch a...

my email is fvullings@gmail.com i seen a pic on this message board or a logging arch. in the the upper left corner, would be nice to see one as a photo. thanks

still got the arch?

would like to purchase a logging arch for my jd440icd. or if someone has made one and could send me photo's that would be cool too.

thanks all

that straight thru shaft sounds great. were could i get one of those?

i am not able to push with my crawler and when i opened up the reverser for a look see, i noticed the oil was burned black. It uses automatic transmission fluid. can someone tell me where to get this rebuilt? or is it something,ic an do, if i am able to get the parts?

hello all i have a 440 icd and have just rebuilt the final drive clutches and the final drives themselves. the machine worked good for a short time but now i notice some problems with the tracks now. when i pull on the levers to run the machine, the apposite track comes to a complete stop. i open th...

hello everyone, i am looking for a block heater for my jd440icd. it has a heater that screws into a plate on the side of the block. cam anyone helo me. i cant source one here.

thanks all

i ve been looking for a block heater for my JD 440icd. it has pipe thread on it that looks to be about 1 1/4 inch and screws into a plate that is bolted to the side of the block,and is on the same side as the governor. if anyone can help me to source one, i would be grateful. take you fishing if you...