JDcrawlers Messageboard

Pin or bolt on pedal at cross shaft is ok will pull engine next week and see what is going on something inside torque tube at the yoke I am guessing,maybe the clip on the throwout yoke has come off at free play eccentric bolt ,also maybe change throw out bearing while I am in there. thanx for the he...

Free play adjustment bottomed out,gears grind trying to shift but clutch does not slip,what is worn out?throw out bearing or pressure plate fingers or should I replace everything when I pull the engine.anything else in there that wears out.any help much appreciated,thanxTim

I just installed a pto shaft on my 40c five roller.The ones for the crawler is different than the ones on the tractors being longer on the part that fits into the cavity of the crawler.I had a short shaft from a 40w.The coupling used on the tractors are p/n m2746t or m2350t and has changed to t24774...

mine was stuck in the engaged position sounds like yours is stuck in the oposite position?? moving it would not break that free

Last year I bought a mt john deere tractor with the same problem,the clutch was stuck from sitting a long time.I have a 12000 lb winch in my trailer which I drug it on to the trailer with and when I got it home I rolled the tractor aft on the trailer as far as I could without rolling it off.Took a t...

Thanx for the reply I thought it was a jd replacement block however it runs good and has been a workhorse in clearing the pasture.I was quite surprised with its performance,but a 350 is kinda rare here in Ga.which was what I was looking for.Tim

I am new to the jdcrawler web and have found it full of info and advice.I have a 40c 5 roller i bought last year to clear overgrown family pasture land of thorn bushes and privot hedge.This crawler is a powerful machine,pushing a big load up on a pile it will spin both 14 inch tracks.Well pleased wi...