JDcrawlers Messageboard

As usual n the blamed thing.... first of all i actually had ma deere electric shop check her out about 2 years ago, they actually did replace that copper stud/contact and cleaned her up...would you believe $5.00????? and yes that was the problem then... Now, i just pulled it this morning, pulled the...

well folks someone here aught to know...my 6 volt starter every once in while seems to have a dead spot or maybe my bendix aint kicking back properly. is dead stick like no juice and i know battery up and good. usually i have to pull starter and spin by hand and play with bendix, put er back in and ...

to get to your profile...when you click on the login box, it shows the profile access just click on that and fill in location.

Jay,
check driveshaft and u joints

i have jd440ic and i do have an inline filter on mine, these old machines just don't have the room to put filter n a 'good' place, mine works great keeping the loose rust out of the carb, have had it on now for a couple or3 years and 'do not have' a fuel flow problem. it is the cheapest and smallest...

beautiful machine!!!!
welcome.
helps if you add location to your profile..

ok guys, I got a question about his left steering brake casing....I have jd440 ic also....and my bung hole and cover is on the front side of the housing, i notice his is showing up on the rear side and the donor i had from a loader was the same as mine.....what is different, could that be off a 350 ...

first thing you need to do..is add your location to your profile..someone may be close by to help. will probably need to drain and clean the fuel tank unless the tank is near full there will be loose rust and other stuff in it. will need to find out what size battery whether 6volt or 12 volt. if 6 v...

re..floating axle..

Well Stan,
thanks for that info!! Just checked and my sons f250 heavy duty does have the full floating axle, so that is a relief and will be using it to get that down the road. Thanks to all for feedback

so to clarify...full floating rear axles....fordf250 heavy duty 2013...would that have floating axle and how do you tell or find out?? missed it and bought 9000 gvwr camper, looked like 5000 gvwr in poor light..pull behind and need to pull it 500 miles, don't think i want to pull with my half ton, s...

Not sure of interchangeability of reverser from 440ic loader reverser to your wheeled, i do have a donor one on hand that seems to function if you would want to test it, i know it snaps very well, just don't know what the clutches are like in it. Have been saving it to use on my jd440ic, cause mine ...

That would indicate reverser rebuild...front half worn, though you mite try adjusting the front clutch..also check fluid level see if low.. Though you state put reverser in reverse and put in reverse(tranny???) ..reverse an reverse would be forward movement..what does it do in forward gear in tranny...

Bent, There were a lot of pics lost from that site once they started charging for use of their site....way too many of them....thats why we got the "dedicated pic server" set up for the crawler site.....you need to email Lavoy to advise him your chosen login and password for the pic server and read ...

Bent, pics are not really too big to load..they do take up your page though...i cannot seem to find where you uploaded them in the "dedicated pic server" if not there how are you loading them? Pic server formula needs that /normal/ typed in the code to keep it a bit smaller..actually is a way to hav...

How about harbor freights chain saw sharpener? any luck with that???? tried it couple times, looks good put on saw and dam thing cuts crooked...i can use hand file and do better and i can't hand file for crap..easier to go buy new chain....!!