Search found 758 matches
- Sun Sep 24, 2017 7:22 pm
- Forum: Show & Tell
- Topic: Cheap Winch
- Replies: 5
- Views: 8364
Re: Cheap Winch
No that is not one third less money it is one third of the money. Just my old proof-reader self acting up.
- Thu Sep 21, 2017 7:52 pm
- Forum: Late model JD crawler technical support
- Topic: 400g outside track width
- Replies: 1
- Views: 2365
Re: 400g outside track width
Here is a spec sheet for a 400G http://www.murphyused.com/images/specs/102.pdf I think the width is 64 inches given the track gauge is 50 in. and grouser length is 14 In. but I have never measured one.
- Thu Sep 21, 2017 7:23 pm
- Forum: Show & Tell
- Topic: Logging Set-Up
- Replies: 9
- Views: 11655
Re: Logging Set-Up
I must say I like that "factory" seat in your 350 D.
Bryce
Bryce
- Sat Sep 09, 2017 4:52 pm
- Forum: Late model JD crawler technical support
- Topic: grease plug on tensioner jd450
- Replies: 16
- Views: 12386
Re: grease plug on tensioner jd450
You need a ball large enough to cover the opening the grease comes out through, but small enough the grease can get around it and out the relief orface. I would say somewhere over a half the diameter of the plug, possibly 2/3 or 3/4 the diameter of the plug. I do not believe it is a critical diamete...
- Tue Aug 29, 2017 7:27 pm
- Forum: Early model JD crawler technical support
- Topic: 1952 John Deere MC Crawler
- Replies: 7
- Views: 7619
Re: 1952 John Deere MC Crawler
Just Idle curiosity but did Wisconsin ever build any water cooled engines? All I have ever known of are air cooled.
Bryce
Bryce
- Fri Aug 18, 2017 5:00 pm
- Forum: Early model JD crawler technical support
- Topic: 420 crawler engine surging
- Replies: 21
- Views: 18032
Re: 420 crawler engine surging
Be sure you have the throttle plate and choke plate in the carb. wide open for no air flow restriction. Possibly even remove the air cleaner. For Compression tests. The added oil in cylinders helps the rings to seal, if compression stays the same after adding oil it indicates the leak is at the valv...
- Sat Aug 05, 2017 12:01 am
- Forum: Off-topic discussions
- Topic: farmall h 12volt gen system
- Replies: 2
- Views: 3964
Re: farmall h 12volt gen system
Most all alternators were built to be used as negative ground. If your IH was used for a while with an alternator, it is probably wired to be negative ground and no good reason to change it now.
Bryce
Bryce
- Wed Jul 12, 2017 6:41 pm
- Forum: Off-topic discussions
- Topic: old road grader
- Replies: 3
- Views: 5028
Re: old road grader
I believe this is it. https://www.youtube.com/watch?v=8N7NX-H7IyY
- Mon Jul 10, 2017 6:28 pm
- Forum: Early model JD crawler technical support
- Topic: 440 diesel
- Replies: 12
- Views: 10149
Re: 440 diesel
How are you going to adapt from 7/8-13T to 1"-6T for the shaft?
Bryce
Bryce
- Mon May 22, 2017 11:19 pm
- Forum: Off-topic discussions
- Topic: Electric Motor Question for Sawmill
- Replies: 4
- Views: 5506
Re: Electric Motor Question for Sawmill
Get a three phase converter. Run a three phase motor off single phase power. Google or Wikipedia has lots of information on them and also Wikipedia has a big page on horsepower.
Bryce
Bryce
- Tue May 16, 2017 7:37 pm
- Forum: Early model JD crawler technical support
- Topic: jd 2010 ignition ?
- Replies: 5
- Views: 5261
Re: jd 2010 ignition ?
This is a gas crawler I assume. Disconnect the battery cable. Or quickly remove the big wire from the coil, but you will still have current thru the points and coil primary.
- Fri May 12, 2017 7:23 pm
- Forum: Late model JD crawler technical support
- Topic: final drive
- Replies: 3
- Views: 3793
Re: final drive
I think John DeMarris could probably give you chapter and verse on them. I see him on Yesterday's Tractor as "jdem" now. and I have his email as "wrenchalot at yahoo dot com". I bought a Case Manual for my 580CK from him when he was moving from NewYork to Michigan. For the email forget the quotes an...
- Tue May 09, 2017 7:48 pm
- Forum: Early model JD crawler technical support
- Topic: JD 1010 blowing coolant
- Replies: 11
- Views: 9522
Re: JD 1010 blowing coolant
Stan the two stroke Jimmy diesels do not have INTAKE Valves. They have exhaust Valves. The two cyl. 53 series only have two exhaust valves per cyl. Bigger engines (3 or more cyl.) can either have two or four exhaust valves per cyl. depending on the head. The rootes blower on the side is used as a sc...
- Mon May 08, 2017 11:38 pm
- Forum: Late model JD crawler technical support
- Topic: JD 350 Reverser Adjustment
- Replies: 4
- Views: 5137
Re: JD 350 Reverser Adjustment
O.P. I get an Error 404 on your link.
Bryce
Bryce
- Thu Apr 27, 2017 12:03 am
- Forum: Early model JD crawler technical support
- Topic: Early and Late 440 Final Drive Housing Interchangeability
- Replies: 19
- Views: 17897
I do not see where that would prohibit interchanging the housings unless they needed more clearance for the 56 tooth bull gear. And then the new would replace the old but not the other way around unless you did some grinding. After thinking for a minute, are the bull gears in the final drive housing...