JDcrawlers Messageboard

i dont know that machine but you might look and see if you can drill it and install a zerk so you can grease it once in a blue moon? just a tought

Andrew you ever find out what was wrong?

Hi guys anyone have an extra fuel tank support? (under the tank near the rear)

i hpoe you did not do a bad thing i dont know of any deere after 1965 that uses 90 wt they all use 303 hyd.

took about a day to get the clutch out having to replace the fibers found some used $80 steels used $72 had a throw out bearing on the shelf had it for about 20 years having to buy center hub $50 had presure plate rebuilt $100 and brake band relined $75 and while i wait for parts i remounted the alt...

yes you can replace just the one gear i douth you need to replace either one though

unless they are worn down to thin as razors they should be fine how much wear? do you have?

well i broke down and started to repair my loader i got in dec. pulled the left clutch out today with some heat (all the pins were rusted in ) had to use a puller on the inner shaft it was not easy but could have been worse had to use a chipping hammer to get the dics and steels out. now the hard pa...

yes you can put the later spin on filter on an early block

the sleeve seals on the bottom of the sleeves are leaking i just did the seals on mine

no your not i have 3 2010s 1 loader 2dozers both with 622 6 way hyd loader has mod #36 ripper dozer has mod # 35 ripper

Nice looking machine as for the plate gasket if it is bad coolant will run on the out side of the block if the sleave seals where bad it will run coolant into the oil pan the only ways to push the coolant out of the rad. is a bad head gasket crack in a sleave which i dout or a cracked head or a stuc...

one good ? thing about it going through the deck is that it stoped sliding sorry i had to say it

i have a 2010 and it should be about the same,on mine ( diesel) you have to take the fuel filters off two nuts and the main cable and the smaller wires and it should come right out the top

i have two with the same crack they can be brazed from the out side you cant get them from deere any more but you can get the gaskets