JDcrawlers Messageboard

also look at the bolt that hold the bell housing in the frame they break may times in the hole that they pass into the clutch housing are sunk in the frame if thats what you see get out the welder and some pipe to get them out rt side upper is mostly what you may see dozer / loders have smaller pads...

TRY HOBB CARB SHOP IN WINDHAM N.H. GOOD LUCK THEY HAVE A LOT OF PARTS

MURPHY TRACTOR EQUIPEMENT HAS THE SPEC ON LINE

one weld on this site has one I ASKED HOW MUCH BUT NEVER GOT BACK TO ME

SEE THE SERVICE MANUAL IT TELLS HOW TO ADJ IT GOOD LUCK

SOME 450 WITH HLR TRANSMISSIONS NEED THE FRONT INPUT SHAFT SEAL REPLACED YOU WILL SEE A LEAK ON THE SKID PLATE UNDER THE TRANSMISSION YOU WILL NEED TO PULL OUT THE MOTOR TO DO THIS JOB PARTS ARE ABOUT 75.00 BUCK IF IT WHERE THE OIL IS COMING FROM NO A HARD JOB BUT LOTS OF PARTS MUST BE REMOVED TO DO...

i change out the bottom bolt for a stud it makes it ease to take off the nut and also when you holding up the 40 lbs stater it makes better good luck i had the one on me 450 out 5 times over the years

hi guy/girls looking for rock sheld for my 450 b can anyone lead me i the right diriction thanks cary FOR THE TRACK SPRINGS