JDcrawlers Messageboard

It should be OK. Be nice to know if the brakes work before you start down the hill. If I remeber right they should roll freely just with the trans in N

The guards are the roller guards. Tried both places (tried Wengers a while ago, I live close to them) Still no luck. There was one on ebay but I got sniped at the last minute. Thanks anyway.

Deere.com has an online parts catalog. Just navigate through construction and then go to parts then parts catalog , the type in your model number

A winch will make a difference, as those machines with a winch will have a reverse gear. Reverse is located straight ahead of 2nd gear. Machines without reverse dont have the slot on the bezel. Also my machine has the pattern on the shifter knob. The pattern should look kinda like below. Hope this h...

The serial number you list is incomplete. The first digits indicate if its a loader or not it should read like JD350CB2xxxxT. The letter B indicates that its a loader. Also I thought that 75 machines had a 3152 still. I have a machine with a later serial than that and it has a 3152 in it. Any kind o...

Any one have (or know where i could buy) rock guards for a 350C Loader? JD Part # AT18872.

-Andy

There are two shaft end caps that support the reverser rear clutch shaft and countershaft. They have an O-Ring around each cap. There is also a seal in the rear clutch support cap. These caps bolt onto studs (older models) or 3 bolts. They have shims under them and set the preload for the reverser b...

Looking for a 350C or 355D Crawler Loader, preferably in the northeast area. reply or E-Mail me @ CaterpillarD8RII@aol.com