JDcrawlers Messageboard

If there is room an internal pipe wrench will work.

Picture server is still down. Sure hope it is fixed and not lost.
Lots of good pictures and info there.
Steve.

It may be the dampener ring in the injection pump failing. Remove the fitting on the pump for the return line there is a small clear check valve ball in the fitting. If it is plugged with small black chunks the dampener ring is failing. Search on this site for “mouse turds” Your problem could still ...

smitty906 JimB and JAJ gave you some good advice above. Make sure the pan is straight and the bolt holes have been flattened. The pan bolts are 5/16 x 3/4”. Some of the holes are blind holes and are just a little deeper than the bolt length. Check that the bolts go all the way in with the pan off. T...

Cut open the old filter and see what’s in there.

Look at the first post under Lavoy’s little shop O’Deeres.

Thanks Jim That is what the JD parts man suggested also. He also took me in the back and showed me all the teeth options that they stock. I did some looking online and see some that are similar in design. So lots of options. The 440IC 831 has a big hole in the side of the block so it will be awhile ...

Well I stopped by the JD dealer today and they say not available. Darn I had high hopes. I have a few pieces of old cutting edge, I think l will try welding a piece on. If any of you come across a used tooth let me know.
Steve.

Problem solved. I was looking up U 10779 instead of U10779. I will order the tooth from the Pape dealer.
Thanks again Jim.

Thanks Jim I had checked online with the nearest RDO farm dealer and the next nearest Pape construction dealer. And didn’t find it.
I will call the Pape dealer on the phone.
Steve

I am looking for 1 bucket tooth for a 440ICD 831 loader bucket.
Thanks.

I had the wrong info to start with on a reverser. Got it fixed about the same time you posted.

13 gallons. For the hydraulics 8 gallons for the transmission

Most good hardware stores will have a ball bearing assortment like this.

dtoots1 The front idler on your 420 has had a lot of repair work done to it. If you are worried about it holding up you could reinforce it like the the one in the picture below. It has had plates welded to both sides between the spokes. The other pictures are the front idler on the other side. This ...