JDcrawlers Messageboard

I believe deere only Item part# T24774 cost $90.. here in Vermont, best of luck, Mark

sorry but you have to go thru the top also to change the input.. the front cover mostly just holds the tranny pump. bearings and seals,,Mark.

there are two part numbers for these frames.. bu10749 is for ser # 296764 and under for 450c at58689 is for ser# 296765 and up for 450c if the 450c frame has almost the same serial number as your 550 it will fit. there is a serial number break for the 550 as well which corresponds within just a few ...

Just checking but if the pump seals on the injector pump shaft are torn or worn,,, that is the usual source of oil pan filling with fuel and will ruin a motor in a hurry.., best of luck Mark.

As you sit on the machine the hydraulic tank is on the right,,, underneath the tank near the rear by the canopy post but underneath is a plug to drain the tank... if you let it sit all night the water will go to bottom of tank and you can turn plug out slowly and drain just the water... if it is rea...

When you say way to much slop... normally all the slop would be in the mechanical linkage before the valve body which activates the valve body. look at the pins and bushings in the lever controls... just wobble them around and watch how much movement it takes before the valve spoll moves... chances ...

Ha, I like Lavoys' reply... get er done.

JT, something to think about. the bolt is the adjustment side of band and the other end is the fixed end.. so when unbolting the adjustment side (which is your bolt) the band will have a natural tendency to spring out toward the front side of the clutch housing because other side of band is still he...

Hi , I was wondering when you would notice the welded frame and the 3" difference between a loader and a dozer. you have done a lot of work.. now lets take some time to think about your situation what still needs to be done and what you get for your effort. #1. now that you have the 450C totally str...

If you could post a picture it would help so we are on same page of thought to give advice, goodluck mark.

Dr. Loch if you mean the big stepped pin I have several, and maybe the others as well but give Lavoy 1st chance please, thankyou, Mark.

I have had the troubles everyone else has advised you on but also on the 450E you have a different newer style pump then the one in the picture, so I am not sure how that will re-late to the mouse turd diagnosis, but it is quite true that blockage of return lines will not let engine run. If that see...

that is correct, they have a machined indent on inside of bolt. Do you still need a picture? if not $22 each plus $7 for flat rate shipping thanks, Mark.

Hi , I have some of those if Lavoy can't find you any.

I could post a picture on Vermont craigslist for you to look at, as I don't know how to post pictures here. thanks and goodluck, Mark.

Paul,, I haven't been on much lately but I thought I'd chime in on this subject, I was down to rutland last week delivering a 450 log arch to a guy,, small world!! Any way as you know ,I sell a few used parts and dozers as a part time hobby kinda thing in the winter. I have owned jd450's since 1979....