JDcrawlers Messageboard

You are less that 200 miles from Johnson Vt Look on CL Vermont listings

Mark has a good selection of 350's. He is a contributor on this site.

were the pin goes through the cylinder towards the outside of machine you should find a bolt
If you are rebuilding yourself my 350c cylinder had a set screw and locktite holding the gland nut or rod guide.You may have to put heat on it .

If it is a loader it has a hydraulic filter in the tank pull the top off the hydraulic tank.See if the filter is plugged.
It may also be a pinched hose or metal line. The low pressure hose runs along the frame on right side the high pressure line mostly metal runs along frame on left side

The serial number tag should be on the plate below the seat. Under your right leg when you are sitting on the seat.

In the Northeast if you plan to use the machine in the winter I would go with 2 batteries. A block heater would also be a good investment. I have good luck with a 2000 watt tank type circulating heater. I plug it in about 1 hour before trying to start the machine. You can feel the return hose if the...

I pulled a link from each side on my 350 ten years ago no problems.
That machine is used about 100 hrs a year.

I would pull the fuel line from the tank at the fuel pump.There should be a good flow of fuel.If not use air pressure to blow back into the tank.The line may be plugged with sediment. If that is the case the tank will have to be flushed

Is that backhoe unit a permanent mount or will it come off easily when not needed.

A good place to look in your area would be the Lancaster Farmer weekly paper. They have many listings of equipment for sale along with listings for most of the auctions in Pa. and the North East. But keep in mind good machines are few and far between. I was looking for a 350c loader for 3 1/2 years ...

welcome there are 2 manuals listed on ebay at this time $175 and $200

parts manual $100 those are about average prices..

You may have already checked but if not pull the fuel line at the fuel pump.If you don.t have a good flow loosen the tank cap and blow air into the fuel line with a compressor that will unplug the screen at the bottom of tank .that's the quick fix but the tank will have to be cleaned to solve the pr...

My parts book shows 2 filters prior to 65 at24274 element filter 7 1/4" and after 65 at45422 return line filter 9 1/2" The service manual shows 2 filters but no explanation If you were at an ag dealer they have little or no information on the industrial equipment. an industrial ,yellow , dealer woul...

Yes you are missing the lever #T21136. Being that you have the radiator removed it is not a problem. Spray some lubricant on the splined shaft Than use a pry bar to slide the sleeve forward.It should move with little effort. You need an opening wide enough to get the belt through. That disconnect wa...

JT I stand corrected on my terminology I should have checked the parts catalog prior to posting. John Deere refers to the part as a rod guide #46600

Leonard thanks for the information on locktite

The end cap is the part on the end of cylinder that holds everything together the piston rides through it.
Usually has an o ring seal and threads that screw into cylinder end.This cap must be removed in order to get the piston out.