JDcrawlers Messageboard

for sure, I'm reminded of one very big spruce that was beat up by a big wind and. when I started to cut into it, it spun 180 degrees and wobbled for a few moments, I ran as fast as I could away from it, over litter and under growth...it fell not far from me and then I realised....Why am I still hold...

So good you were not hurt more seriously. Sounds bad enough, 20 stitches will add character to that forehead for sure.

Gun shy is a good thing. Some lessons are not intended to be learned twice.

I have a hoe however it is a case and fits nicely onto the 350b using a custom made bracket. The downside is that I also have a ripper on a 350c that mounts on a hoe bracket and it sure would be nice if they both could be used on the same crawler. The brackets are not compatible. I am not needing 35...

I am wondering if the issue is in the transmission ? Or another issue other than reverser. Jumping out of gear has everything to do with the tranny. This does not explain the teeth in the reverser case or the shim. Did the reverser lever travel front and back when the tranny was in neutral clutch pe...

if there was a like button here..... I would be pushing it.

you can look model years up here in the forums under FAQ. (Frequently asked questions) Forum members post a lot of good look up information there.

I have one on, and the other off, on my 350b. Three times I have had the track off on the side without the guards. Every time in a hole or in deep bush, Each time I promise myself to put that one back on. It is still off. This spring I promise.

I havent been following the board as closely this year and missed your posts. Welcome fellow Saskatchewan member. I did see your ad on Kijiji and did not think you would have much problem finding a crawler or two. I have had trouble finding a canopy (i have one now from Alberta) and a log grapple wo...

It h as been 6 years since I had the same problem. I ended up pulling the rad and hyd pump so I could get some anti seize on it and work it loose. no grease nipple from factory, now i keep testing it a couple times a year.
Scott

WE should all give Lavoys facebook page a fair try. everything works perfect there and photos are easy.

Follow up to my comment, my ripper has 5 holes for shanks as Jtrichard noted in his post. As does every deere ripper for 350 and 450s that I have seen.

I recently purchased 2 shanks for my ripper installed on my 350c. Deere had them in stock as well as the spring clips for adjusting them up or down. The cast wedges (about 4 inches long by an inch wide+-) that the spring clips attach too, are discontinued. Although, they are easily cut from an iron ...

I have one already, I wont be bidding.
Scott

my 450c will do that if it is a bit low on fluid. I discovered it pushing a burning brush pile into a hole. Lucky I had a 350 with a winch on hand or it would have burned.