JDcrawlers Messageboard

hello, please take plenty of pictures of the seals and bearings. thats were mine sets now,do i need a tool to put the seals in? will keep watching your progress. thanks Eric..

working my overtime over here in wells trying to finish mine to. cant wait.. Eric.

hello, im not sure what the 1010 has for lifters but if they are hydralic and you set the valve with them blead down then when you run it they will pump up causing your problem. if it has solids than recheck valve clarance one more time.

wow preheated hydralics for the winter, you may be on to something!

wow what a job!my axles are loose, how bad was it to fix them?

nice job terry! around here when they say selective cut it means, take all the good wood and run over or scar up any junk that was left standing, after a skidder has left your property it is a total mess with wheel ruts so deep,every tree backed into, and roads plowed with loading pads so a trailer ...

id pass on that shop.sounds like they are used to small block chevys and not john deere cranks. it will cost you more to let these guys experiment on your crankshaft than its worth. and they dont need bearings to turn your crank all they need to know is stock and then turn it 10 or 20 thousands down...

if you dont think that there are scammers on craigslist than just read their warnings about it, im sure they wouldnt waste space to tell you about something that wasnt there. its at the top of the page.. Eric

man thats a neat snow pile! cant wait to finish mine... Eric

hello mapaduke! i seen your dozer at the show, there was another jd dozer there on a trailer, it was a small home built dozer built out of a jd farm tractor. it was well done. i have a picture of it somewhere. i think i talked to you about yours. it was a great looking dozer. that tractor show is re...

my garage is 30x40 how many boxes will i need to order? he he

maybe just wave a torch over her a few times like you would shrink tight, that should do it!!

hello! im no expert but i think that those grousers are a little aggresive for a crawler...

sorry i dont have one to give you, but i am intrested in your results, i know of one guy that i work with and his are shot. i tryed to get him to take one apart to see if some sort off bushing could be made cheaply. his has frozing to the shaft and the shafts turn and are wearing thru the saddles, h...

yes i have dealt with them, i was very pleased with them also. the owner answered the phone every time that i called, he loves to talk to you and he is in no hurry to get you off the phone, i live in maine and my order only took two to three days to get here. i would buy from him again no problem!! ...