JDcrawlers Messageboard

hi guys, wanting to know the weight for a complete 602 blade ?

the 440ic is suppose to be 6,024# with 10" tracks and no attachments,

ulf, i just remembered reading about the oversea's models that were assembled in germany and had perkins 3 cyl, engines,, i was reading your posts but now i see your at seven pages so i didn't take the time to see if you've positively identified the motor.,,,also,what does fuel cost in sweden?

we had a 420 tractor doing something of the same,,, seams the linkage and spring was worn along with the worn hole,,, was all loose enough to allow carb to vary , it was a simple fix.

we also had some jimmy's ,, one of them(12v71) we had to reach down on the pump and pull/hold a lever till dead,,,, the other was in an international truck and had its own pull lever... also , the 12v had safety gauges that would trip a solenoid on the pump in case of low pressure, or high temp. , t...

you guys have any luck with changing out the oilbath to the dry type filters?i would consider this only because i plan to do some steep climbing and oilbath might not be so good.

pop pop wrote:it doesn't show up again... maybe make a link to it

still not showing up,

i want to hear more about this crawler, send me a personal message

i would avoid an electric winch like it was the plague., as i went that route and on the first attempt at getting the unit up a steep bank~20ft. i ran the motor outa gas due to the incline,, relied on the battery, and winch ran the batery dead before it got to the top, got a second battery and it fi...

back in the 60's my dad had a 420 wheeled tractor with the trencher on the back,,, it had the widest of wide tires, fluid filled,, , it would climb almost straight up , ,, as a kid this always scared the shit out me when the guys were doing this, ,of course nobody would be on it ,,, the only problem...

thanks for the tidbit Lavoy,,, this might have recieved the transplant,,, i read somewhere (two cylinder magazine)that the carb intake tube was slightly larger than normal on some of the gas engines to add HP.in an effort to compensate for removing the jimmy engine, ...it looks like this one has tha...

is there any other place on this crawler that has the serial number?
the lower dash plate with model and serial number is not there,
the leftside flywheel casting flat spot, yes, but any other serial numbers or numbers that were "model specific"? that would be on the main body.

this is throwing me for a loop, a 440ic ,serial # is 4405xx so that designates it to be a 1958,right? ok, it has a reverser, it has a 5 speed trans, has a pto lever but no pto shaft, the carb intake is a long flextube going back to a oilbath mounted on the rops. it has a throttle lever in the center...

hey everybody, the pictures of this look pretty good
(i had emailed a request for the pix),,, its too far from me thou.

hi eric, well before you get serious, look at the shipping charges involved, i'm in arizona,,unless your a snowbird(annual winter visitor),,, we might as well be on 2 different planets,,,, 44 pounds clear across the usa?? hey i don't think my howitzer can reach that far,heehee,,but if my results wor...