JD1010C with a JD810 front end loader in need of a tooth

[Rich Robert]

I have a JD1010C gas, industrial model with a front end loader. One of the teeth is broken on the bucket which i would like to replace. Its app. 8 "long and 2"wide attached using a split tongue arrangement with 2 3/8" bolts. It does not need to be new. Thanks


Rich/JD1010C and 1930 Model AA ford dump truck

[jdemaris]

I have a JD1010C gas, industrial model with a front end loader. One of the teeth is broken on the bucket which i would like to replace. Its app. 8 "long and 2"wide attached using a split tongue arrangement with 2 3/8" bolts. It does not need to be new. Thanks


Rich/JD1010C and 1930 Model AA ford dump truck

Here is a copy of the answer I posted to you in the other forum.


I have the same machine except my 1010 is a 1960 with a 810 front loader and a rear ripper.

The original Deere # for that tooth is U 12910 U. But, when you order it from Deere they send you something different without any sub numbers. They give you a generic replacement tooth needing a new type of shank to be installed. You can buy the new weld-on, or bolt-on shanks from many places. Deere basically markets stuff made by other companies.
I put weld on shanks on my front bucket, and can now buy teeth for $5 each just about anywhere.

Deere tooth catalog is at:
https://jdparts.deere.com/partsmkt/docu ... eethBR.pdf

I bought mine on sale in a kit from:
http://www.excavationsupply.com/BucketTeethIndex.htm