440 w/loader dimmensions

General help and support for your Lindeman through 2010 John Deere crawler
Post Reply
User avatar
locomechanic
40C crawler
40C crawler
Posts: 17
Joined: Sat Nov 08, 2008 11:33 am
Location: Elizabethtown, PA

440 w/loader dimmensions

Post by locomechanic » Mon Dec 01, 2008 5:20 pm

Hello, I wanted to see if anybody knows the dimmensions of a 440 w/831 loader, mainly the max height and width. Any help is appreciated. Thank you! Sam
440ICD
2-53 Detroit

User avatar
Lavoy
Site Admin
Site Admin
Posts: 11108
Joined: Sun Apr 03, 2005 8:32 pm
Location: North Dakota
Contact:

Post by Lavoy » Mon Dec 01, 2008 7:55 pm

Width should be about 5', don't know on height, but somewhere over 5' as well.
Lavoy

yellowcrawler
420 crawler
420 crawler
Posts: 38
Joined: Sat Sep 23, 2006 12:20 pm
Location: Columbus, Ohio

831 dimensions

Post by yellowcrawler » Mon Dec 01, 2008 8:09 pm

From Deere Spec sheet on 831
Overall width (over idler brackets outside of 12" shoes) - 61 1/8"
Height - 70" (at highest point the pivot for bucket arms)
Overall Length - 105 1/2"

Walter.
1960 440 ICD with 602 blade
1960 440 ICD with 831 bucket
1960 440 ICD with 831 bucket, center throttle

User avatar
shinnery
350 crawler
350 crawler
Posts: 774
Joined: Fri Jan 27, 2006 4:55 pm
Location: Hawley, Texas

Post by shinnery » Mon Dec 01, 2008 11:42 pm

I have a "pdf" file of a 831 brochure (4 pages), don't remember where I lifted it, with lots of good info on the 831 loader. I don't know if I can attach it on here? Maybe e-mail it to Lavoy or his webmaster to be included in th FAQ section? It lists 62" wide, 5' 10" tall, and 14' 3" long (with scarfier).
Bryce
:?
No trees were hurt in the creation of this message.
But, many electrons were terribly bothered.

440IC/602, 2-440ICD/831 MM UBU-LP, 445N-LP, 445E-LP, BIG MO 400-M, 4 Star-LP M5-D, M5-LP, M602-LP, M670-LP, G900-LP, G900-D, G1000 Vista-LP Case 580CK

User avatar
locomechanic
40C crawler
40C crawler
Posts: 17
Joined: Sat Nov 08, 2008 11:33 am
Location: Elizabethtown, PA

Post by locomechanic » Wed Dec 03, 2008 3:20 pm

Thank you all, for your help! I have more room than I was originally thinking as far as the height goes. I am getting everything ready for it when it gets here. It will be arriving sometime next week. Again, thank you. Sam
440ICD
2-53 Detroit

Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests