Need Engine Block for 2010 crawler

[royboy]

I am rebuilding a 2010 crawler... after removing the sleves I found a hair line crack in the block between two of the cylinders and it runs down to the main shaft...

So, would like to fine a block... Any ideas??????

Thanks,

RoyBoy

Fort Madison, Iowa 52627 319 372 3529

[Lavoy]

That might be tough, that is a common complaint. Friend of mine has 4 blocks, 3 of them have cracks there.
Lavoy

[Rockpig]

HI, we are all but in the same boat, apart from i'm in England and you in USA.

I have a couple numbers of places over your way that have helped us out no end for parts for the 2010 crawler.

1, PB&H equipment
Antrim new hampshire
1- 603-588-3005 (thanks to Andrew for passing me this number)

http://www.dierjdparts.com/ Here is a link for (Ted) in Canada, also very helpful.

Hope this helps you out a bit?

Ali

[JD430C]

Good luck finding one, I gave up after a few months and bought a complete engine. IF I find one I will let you know.

Andrew

[claude murwin]

gas or diesel ? I should still have a diesel outta 2010 wheel tractor

[royboy]

A big THANKS to all for the info on finding a block... I will check out the links and make some calls... It is a diesel engine... and I am learning a lot doing this myself... Hope it runs someday?????

Thanks again...
royboy

[Stretch]

I have two 2010 diesel blocks if your interested.

[Rockpig]

I have two 2010 diesel blocks if your interested.

HI, how much are you after for 1?

Were in process of stripping ours down. Not sure if we need one as we will get it checked out first.

Thanks

[Stretch]

I don't know what a block is worth, make an offer.