Need Engine Block for 2010 crawler
Need Engine Block for 2010 crawler
I am rebuilding a 2010 crawler... after removing the sleves I found a hair line crack in the block between two of the cylinders and it runs down to the main shaft...
So, would like to fine a block... Any ideas??????
Thanks,
RoyBoy
Fort Madison, Iowa 52627 319 372 3529
So, would like to fine a block... Any ideas??????
Thanks,
RoyBoy
Fort Madison, Iowa 52627 319 372 3529
HI, we are all but in the same boat, apart from i'm in England and you in USA.
I have a couple numbers of places over your way that have helped us out no end for parts for the 2010 crawler.
1, PB&H equipment
Antrim new hampshire
1- 603-588-3005 (thanks to Andrew for passing me this number)
http://www.dierjdparts.com/ Here is a link for (Ted) in Canada, also very helpful.
Hope this helps you out a bit?
Ali
I have a couple numbers of places over your way that have helped us out no end for parts for the 2010 crawler.
1, PB&H equipment
Antrim new hampshire
1- 603-588-3005 (thanks to Andrew for passing me this number)
http://www.dierjdparts.com/ Here is a link for (Ted) in Canada, also very helpful.
Hope this helps you out a bit?
Ali
-
- 420 crawler
- Posts: 27
- Joined: Thu Apr 23, 2009 6:02 pm
- Location: otego, ny
2010 block
gas or diesel ? I should still have a diesel outta 2010 wheel tractor
1010 dozer,750,dozer,2010 tractor,ac d17,vac case
JD 2010 block
A big THANKS to all for the info on finding a block... I will check out the links and make some calls... It is a diesel engine... and I am learning a lot doing this myself... Hope it runs someday?????
Thanks again...
royboy
Thanks again...
royboy
Who is online
Users browsing this forum: No registered users and 73 guests